Jump to content
SAU Community

Recommended Posts

Hey all, my mum drives a a4 which recently needed new rotors,pads

after replacing the rotors "apparenly 4 times according to audi"

we found they had never been changed , spoke to some people who i dont need to name in cannington, who seemed good people and informed us, we got some lucas pads and brembo rotors put on,

the car made a slight click clunk kinda noise feeling when coming to a compleate stop, still does, how ever during this time mums driving the car down the grame farmer when the right hand rotor falls off and jams on and nearly sends the a4 onto the rong side of the road thru the tunnel = bang.

seemed like a simple thing breaks and rotors. ehh great

just be carefull guys... keep rolling

Link to comment
https://www.sau.com.au/forums/topic/24393-mums-audi-ate-shit/
Share on other sites

I've seen someone on another (unnamed) forum try to tell everyone that brakes are too important to do yourself and that you should leave it up to the "professionals". Whether changing rotors or pads or bleeding the system or reconditioning the calipers.

I've been doing my own brakes for over 15 years (the lot except the master cylinder, including reconditioning calipers) and I've never stuffed up like that. If you know what you're doing, can you really trust anyone other than yourself?

Buy new seals, push pistons out with compressed air (or take caliper off and pump the pedal until it comes out for the bush mechanic version), clean out inside of caliper, hone it if necessary, replace seals, re-assemble.

Repeat for other calipers, replace brake fluid and bleed system.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This. The R34 handbrake icon DOES come up when the brake fluid level is low. You might be sitting right on that threshhold. I have been down this diagnosis path and this was the solution (and it was pretty much as full as your picture is to begin with).
    • Unfortunately the cavaet to that is that while any scan tool should be able to read the code, the workshop will need a consult plug to OBD socket adapter. You don't have a location on your profile, where are you based?
    • @Haggerty this is your red flag. In MAP based ECU's the Manifold pressure X RPM calculation is how the engine knows it is actually...running/going through ANY load. You are confusing the term 'base map' with your base VE/Fuel table. When most people say 'base map' they mean the stock entire tune shipped with the ECU, hopefully aimed at a specific car/setup to use as a base for beginning to tune your specific car. Haltech has a lot of documentation (or at least they used to, I expect it to be better now). Read it voraciously.
    • I saw you mention this earlier and it raised a red flag, but I couldn't believe it was real. Yes, the vacuum signal should vary. It is the one and only load signal from the engine to the ECU, and it MUST vary. It is either not connected or is badly f**ked up in some way.
    • @Haggerty you still haven't answered my question.  Many things you are saying do not make sense for someone who can tune, yet I would not expect someone who cannot tune to be playing with the things in the ECU that you are.  This process would be a lot quicker to figure out if we can remove user error from the equation. 
×
×
  • Create New...