Jump to content
SAU Community

Need To Borrow 32gtr Airpods For 5min Just To See If Mine


Recommended Posts

hey guys is there any1 that i can borrow there 32gtr podfilters from just for 5min to try them on my car to see if thats the cause of the problem? im located in dandy

u can sms me on 0422 607 113 thanks guys help much appreciated

how can pod filters be a problem for anything?

just take em off if you need to test, will work the same as swapping

i wana see if there 2 dirty and try another set to see if it makes a big difference

i wana see if there 2 dirty and try another set to see if it makes a big difference

Unless they were so blocked up that air wasnt even going through them...

You wont really notice a difference.

Totally depends on what problem you have though, but ive never heard of a dirty pod seriously degrading performance

the problem is the revs drop really low sometimes and then back up feels like its gona stall and sometimes it does stall thought maybe not getting enough air.yer i think im gona give em a clean with compressor a bit.and im taking the car down to status tuning 2morow to get checked out so they should be able too tell me.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
    • Well, yeah. But I just expect everything other than my car to feel like a bucket of shit anyway. I still miss my Alfa 116 so much though. You could run over a 20c piece and tell whether it was heads or tails.
×
×
  • Create New...