Jump to content
SAU Community

Recommended Posts

hay guys iv just spend 20k on a rebuild of a RB30/26.

it seemed to run fairly clean on initial start up of engine.

have had the head off and slight tune on idol.

since this the car is miss firing n seems way too rich, fouling plugs and blowing alot of black smoke!

it is missing down low around the 2000-3500 RPM, it runs ok really low in the rev range n when you get it boosting or into the rev range it clears out.

i am wondering if anyone can help point me in the right direction, is this just the tune (i assume it has only been tuned on idol n full throttle not using the matrix mode for the microtech) or do i have a fuel or ignition problem and the computer it self?

could it have anything to do with the heat sensor in the block giving faulse readings, or injectors since they have been sittin for over a year while iv been building this engine?

there is so many things it could be if it not the tune, n i don no were to start.

this car owes me round the 50k mark n it got taken off the road a week after i bought it and has only just been finished now, a year n a half later.

you could imagine my fury as its still not right, any help would be greatly appreciated thanks

Link to comment
https://www.sau.com.au/forums/topic/249227-miss-firing-drama-microtech/
Share on other sites

this will be the best advice you will get.

Take that computer out, burn it.

Get a Autronic / Motec / Vipec computer & install it.

get it tuned and enjoy your car.

If you keep playing around with the microtech you will end up spending a shitload more money on the car for no reason.

Change the ecu. change it NOW.

end of rant

I agree with Guilt toy. The LINK Storm does a plug in for the R33 (i assume thats what you have ?) ... The Vi-Pec is a LINK customised to suit Ray Halls specs. Both work very well.

And even if you keep the microtech, there is no excuse for not using the matrix mode, using the original single rpm load based mode is ludicrious.

I know the Micros have there fan boys, especially rotarys, however from a tuners point of view, there really is alot better gear out there with finer resoloution and much better features that give you the opertunity to make the car drive alot nicer in all the areas between full power and idle !! And thats where you spend 90% of your driving time !

That being said, it still sounds like the Microtech isnt tuned well, and if your adamant about keeping it, im sure you could obtain a much better driving experience while still using it if it was tuned better.

Gary

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Maybe also really stiffly sprung track cars. Get the inside wheel up in a corner and all the fun stops. Also me sometimes (rarely) when I have to stand on the brake to convince the diff to drive the wheel that is still on the ground when I'm trying to diagonally get over severe driveway entrance, etc.
    • I feel like I'm missing something. You had an authorised installer come out and install a new alarm. Post install the car doesn't start, and you aren't getting the installer back to fix what they did wrong?
    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
×
×
  • Create New...