Jump to content
SAU Community

Recommended Posts

gday guys recently had some probplems with my r32 ...it wil start and idle but idle wil slowly come down to a stall and if i try to rev it it wil hesitate something shocking al i can hear is air poping back through the pod filter .. and it wil rev to 4 grand and then just back fire as if rev limit was at 4grand any help please

check your afm and also youur O2 sensor...sorta had the same prob and i changed afm and it fixed it for a bit and then i scanned my car and it said the O2 sensor was buggerd so i just disconnected it and now it runs a dream..hope this helps.

  • 3 weeks later...

yo man this happened to me, what mods are you running on your car?. what you can do is, first clean afm like said above, then check coil packs for any cracks, then make sure all spark plugs are good, and have got the proper gapping.. If it still doesn’t work and if your car has a decent amount of mods, change the fuel pump..

i had the same problem a week or so back, where my car would hit 3.8k-4.2k and start back firing very loud and the car wouldn’t go, so i put a gtr fuel pump in and it fixed the problem so it could be a fuel pump issue

Good luck man

niran

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...