Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Maybe I should dropby EFI and check your car out when I'm coming back from the coast tomorrow... lolz.

Haha itl be like when someones sick and in hospital and everyone drops in to see how you doin.

You getting your ecu 2moz?

yea d000d!?!?!?!

oh thristian i had the alarm installed today :(

well 3point immobilizer wired to the turbot timer :)

oh helllsss yeh

sounds pornographic

well not anymore.. as tristan will be driving the PCE Performance workshop 180.. :):(

oh so thristan bought goldenwang?

oh so thristan bought goldenwang?

trade his 32 and cash tas's way. cant wait till the swap goes down. :(

Oh so PCE Performance has a workshop now?

if you call sharing, then yes :)

as for energex, get my power back on bitchez... needa work on my car.

sharing? maybe.. i dont want the hassle of spending 40k for a workshop setup..

rather i run my business out of a already established premises then doing dodgies with some bodgy workshop

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Yes. Get rid of that battery. It is dead. It will cause problems.
    • Don't assume too much when there is a voltage issue....if the battery is flat and the alternator not charging it is easy for the voltage to drop way low at the ECU due to the draw of stuff like coils, fuel pump etc Whatever you see at the battery with the motor off, it should be at least 13.8 with it running
    • I have been wondering if this is as simple as a voltage issue with the battery. Even on a charger, I can’t seem to get it over 11.8V on the terminals.    Unless the alternator has failed as well, that wouldn’t cause it to die in the middle of driving though. 
    • I’ll give this a shot next time I’m able to wrench on it.    I was able to get my hands on a Haltech Nexus, so that should help with some of the more bizarre troubleshooting. Make sure the CAS is actually sending signal and will be able to set the proper dwell on the R35 coils.    I’ve checked power/grounds/signals at the CAS, ignitor, and plugs and it was all there. Granted this was static with ignition on, not cranking.    I also plan on swapping out the fuel filter and throwing on a fuel pressure gauge at the rail just to confirm I’m getting the correct pressure at the rail. 43psi if I recall correctly. 
    • The attached document is fine. I just downloaded & opened it.
×
×
  • Create New...