Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Its on page 18 of the manwell. Basically go to the menu, press down to go to "Setting", then press the left key so it says "Setting OFF". Thats how I read it anyway.

If you want to drop round this arvo I can have a quick look, I'll be changing my spark plugs though and need to get it done so I can drive to work tomorrow. Should be home by 4:30.

Extend the cabling for the AVCR? I guess so, depends how dodgy you want it :)

Winrar!

ah that off setting. I'll see how I go this arvo have a few things to do. Thanks for that. How dodgy ? Extremely :P

Hopefully have the super gauges turnout by thursday and then you can see how prettiful they are

ah that off setting. I'll see how I go this arvo have a few things to do. Thanks for that.

No problems mang, just send me an sms if you are coming round so I know to expect you.

How dodgy ? Extremely :P

Well OK then :P

Hopefully have the super gauges turnout by thursday and then you can see how prettiful they are

:)

Sarp Mangs weekend of death is over. On my way to uni now only about 5 or 6 hours left on this stupid assignment and its all done. Then its only a couple of little things and exams and im done. f**kin winrar.

Martin i think the German Club closes before the origin finishes

Hmm. Thats a good point. They claim to be open till "late" and origin finishes around 10, but I have found the German clubs definition of "Late" and mine often differ greatly.

If German club falls through, are we going to try and organise something else?

I'm not keen enough to organise anything, but I am keen enough to attend :). Miso is keen for sure.

KEEN

Not for german.

Just for Miso....... never met him, and I need some fresh meat......

Have you seen Rocky four ? You know the bit where the russian comes out and say to rocky " I must break you " thats kinda like Miso, but smaller.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • ECUtalk pages don't mention they support the ABS computer (consult port has more than one CAN), so you might just need a different scan tool. But, I would expect ABS is a different light to the brake warning/handbrake light, do you see an ABS light come on for a few seconds when you turn the key from ACC to IGN? But since you said: I'd have a look at the ABS sensors in the rear hubs to make sure they are not damaged, disconnected etc.
    • OK, if it idles at 1000+ with the AAC, its not an idle airflow problem. The cold start valve just gives extra air when the engine is cold, but you have enough air without it to idle at 1000. I think you are back to a fuel problem, sorry. Can you see the fuel pressure staying constant or does it drop as the revs drop to a stall?  
    • Well, I was using ECUTalk software if that helps? Not sure if that only can see engine codes? Is there any other software I could give a try? Or any way I can get a blink code?
    • I never touched it, it should have. I'll try to give it an adjust. With IACV plugged in, it idles at around 1120RPM on average. Max 1200 RPM, Minimum 1025RPM before it starts dropping right before stalling. Took the data from the Nistune logs.
    • Thats what im trying to solve bro  no one with aem tuner experience would advice  much appreciate 
×
×
  • Create New...