Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

as requested:

desk.jpg

Desk is shared between 2 of us, red line indicates approximate position 'my' desk ends

:( :( :( :( :(

that fkn blows! good thing you dont have any work to put on it :D

damn, were are you to put you footlong sub on that?

man my workbench you could have a party on. Actually come to think about it you could, 2.5mm thick stainless steel is hella strong my hammer can't dint it

Works in service..

11pm - 6am kind of job

I wouldn't need a desk for that :)

Miso, my qualification is in Computer Systems Engineering (Read: Software Engineering). My current role is hard to describe, basically I do semi-HK IT stuff (ie not "Have you tried turning it off and on again" ) :D

Bring it to the German club

German Club when?

See you later Jason, have fun in Auschwitz

It's not such a bad place :)

Nice desk by the way :D You should put up some police line do not cross tape where the red line is :3some:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • If your tuner can't make the car idle like factory, I'd get a new tuner. These injectors are fantastic and I'd have very serious concerns about a tuners skill set if they couldn't get them to idle well. 
    • It's highly likely you will find something. Alternatively, a quick design and order online from chaina and you'll have a perfect solution
    • Idle Lambda target is off by .4 but I reckon the VE table is not correct. If my tuner has no issue using these injectors I will keep them, they are good quality after all
    • I already have an Apexi. Just wondering if it is worth putting in something new since the Apexi is likely well over 10 years old, if not 15. I know the injectors work but they already run at less than rated fuel pressure to make them work properly and idle is basically 1% duty cycle or less. Could be better
    • Nice, I would never have thought in that direction. The actual motor is a cylinder....I wonder if there are any cylindrical heat sinks with the right ID  (and if there is clearance to other components). I think adding airflow is still a thing as well....will check it all out next time it is in the air. Wish I had a hoist...
×
×
  • Create New...