Jump to content
SAU Community

Recommended Posts

This is a very regretful sale, so no low ball offers. As you can see in this link they are very valuable wheels.

http://nissansilvia.com/forums/index.php?s...860&hl=vskf

Wheels are full chrome and in very good condition.

Comes with tyres but no nuts,

Rears are MONONEW Motorway 235/40/R18, new have only been on dyno.

Fronts are VENTUS Sport K104 235/40/R18, 95% tread.

$2900 ono

post-16618-1238326946_thumb.jpg

post-16618-1238326968_thumb.jpg

Haha, thanks guy's. Nah battery in boot on charger but maybe the next project can be an electric hybrid.

Fair sure I've sold em just waiting for the purchaser to receive cash from a sale of his so he can forward it to me, but until I receive the money there still for sale.

i want them!!! but im in qld so tempting would you sell without tyres if so how much? just make it lighter to transport?

lighter for transport shouldn't matter too much, they'll go on a pallet regardless of whether they have rubber or not if you send them through someone like northline >_<

Quite a bit, they are still out of my guards a little and mine were done by all type crash, not a cheap guard roller job.

So your guards had to be flared?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...