Jump to content
SAU Community

R33 Roll Cage! Safety 21 - 6point Competition Cage

MAFIA R33
 Share

Recommended Posts

  • 3 weeks later...
MAFIA R33 Contributor

MAFIA R33

Posted
  • Author
Posted

back up for sale, was pending payment but due to buyer crashing his car its now for sale once again! considering any serious offers around $900

  • 2 weeks later...
smok74 Community Regular

smok74

Posted
Posted

I just sold a PFC with the genuine Apexi add-on boost kit two weeks ago for $1500 - it was a couple of months old and I replaced it with a Haltech...so spewin hey.

As with the cage, NO ITS NOT CAMS APPROVED due to the diameter of the main hoop, its not thick enough..... and as with the sunroof model, all you have to do to make one of these cages fit a sunroof model Skyline, you take the feet-flange plates off, remove about 2.5 inchs off each side of the main hoop, then reattach the feet. This is because the factory sunroof in the roof lining make it all sit a little lower than the non sunroof model.

  • 1 month later...
  • 4 weeks later...
Dad valleyonvia Newbie

Dad valleyonvia

Posted
Posted
cage still up for grabs guy/gals will take $900 cash no swaps

matey sorry been away working my offer is still there but need details where you are and a contact numberfor you i also wont be home again till next weekend thanks

  • 3 weeks later...
MAFIA R33 Contributor

MAFIA R33

Posted
  • Author
Posted

SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD!!

PLEASE DELETE!!!!!!!!!!!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      I am well aware as I did rant at him to buy a MX5, buy the 2.5 before he DIY'ed it, etc as well as do things to the holden. He will obtain a ND. It's the best of both worlds. They look great in person, definitely the best looking one. Just a matter of time now.
    • r32-25t
      NC MX5

      By r32-25t · Posted

      Remember this is the same person who said he’d never own an nc 
    • zique
      Ceramic turbine damage to engine - what did yours do?

      By zique · Posted

      ouch! how is the car now?I had sold my gtr but have been looking into some on trademe and a 260RS but I wouldnt be keen on any repairs needed on them
    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
×
×
  • Create New...