Jump to content
SAU Community

Recommended Posts

send it to ISASO and the process is roughly 10 days. 3200 -3988 after 8am monday morn. ask for micheal or courtney- mention me.

OR carmen imports - craig 38811800 - again mention me.

Link to comment
https://www.sau.com.au/forums/topic/271430-compliancing/#findComment-4612763
Share on other sites

no probs. have seen them go through in 10 days in one shop - craig does them in 10-20 days. if it s broker find out who they are using. there may be a cahnce that I service that shop.

Link to comment
https://www.sau.com.au/forums/topic/271430-compliancing/#findComment-4612785
Share on other sites

cheers chris mate

all i know is its somewhere near indoorpilly i think lol cant remember the fella's sau name.

by the way mate, when i get a car sorted out, i was gonna give u a pm or call about a security system, i heard your a bit

of a whizz with them

cheers

Link to comment
https://www.sau.com.au/forums/topic/271430-compliancing/#findComment-4612793
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...