Jump to content
SAU Community

Recommended Posts

Hi all,

As some of you fine people know i have a white R32 four door that i love a lot ..

However i also have ( or should i say my partner has) an R31 wagon as a daily and it really gets a lot of work....anyone who has a young family knows wat i mean..lol......It is nothing super special and because of that it has never "felt the love" that my other cars have.

As the story goes i decided to spend some time and fix a few things that have been nagging me ( or should i say her ) and give it a bit of a clean! Now im not saying it is amazing..not even close...however it was not the car that i started with thats for sure..it came up great for what it is so i thought i would post up some pics..

enjoy!

post-42356-1245583162_thumb.jpg

post-42356-1245583252_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/275731-ever-neglected-a-car/
Share on other sites

  • 1 month later...

Hi all,

As i have just bought a 4X4..I have no real need for this...It has 180XXX on the clock and is neat and tidy..Any idea what this would be worth with an RWC and a months rego..It is an auto

I know that this is not the classified, but rather than post it i just thought i would give it a bumpy..Its just an EOI.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...