Jump to content
SAU Community

Recommended Posts

Hey guys im looking for an R32 or an R33 has to be auto and with turbo,with rego and RWC i have 8grand to spend im located in melbourne

I have exactly wat ur looking for and im in melb,

Its on carsales: TYD-682

We could come to an agreement, :D

hi ozzigstar..

i have a '97 r33 gts25t series II.. but it's got minor problems. Willing to sell it for very cheap..

http://www.carbuddy.com.au/buy/cars.aspx?s...0&mid=52662

i hope the link works..

problems:

- sunroof doesn't work. gotta manually shut it

- the clear is peeling off the bonnet

- head lights needs to be polished/cleaned

- front brakes are squealing

- few little scratches

- chip on windscreen about 5cent piece

it's complete stock. All services done at EAS performance by George. Mongoose alarm 3 point immoboliser bought and installed @ Stylyn.

If you're interested let me know... will work out a deal!

Edited by kaleh

Hey buddy, got a black 1998 Series 2 R33, comes with a turbo back exhaust (trust), pod, boost controller on 10psi, Car is registered and comes with rwc, located in melbourne, shoot me a pm if your interested

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...