Jump to content
SAU Community

Recommended Posts

Hi All,

Advertising this for my little brother.

HPI SAVAGE X 4.1

Up for sale is my hpi savage x 4.1, I bought it for $900(plus $450+ in options) on it 2 years ago and have not since used it for at least 1 1/2 years ago.

Truck has only had about 5-6 tanks of fuel in and I had not even fully broken in the engine yet.

Last time I drove the truck I broke the rear diff (crown gear I believe) but it’s only about $15-20 and 5 minutes to change. Apart from that the truck has usual scratches but over all it is in very good condition (a clean wouldn’t hurt).

Features the usual such as- alloy diffs, 2 speed transmission, 8 oil filled coil over shocks, TVP (twin vertical plate) chassis, full time shaft driven 4wd, 4.1cc big block engine, 160cc fuel tank for long run time, tuned pipe, 17mm alloy hex drives, roll cage, 2 stage air filter, roto starter with charger for easy convenience, etc.

Additions over the standard savage x 4.1 are:

• wheelie bar

• muffler silencer

• twin stainless steel disc brakes

• Mounted nubz tires s compound on a black dish wheel (was about $200 dollars with the correct hexes as well).

Also glow plug igniter and charger will come with truck amongst other spares ie: glow plugs, filter`s, rotor starter and charger and other miscellaneous items(no AA batteries come with it).

All that is needed to get this truck going once again is a crown gear for the diff($15-20) and some fuel.

After $400 for the lot!

I would prefer a local pick up but I will post at the buyers expense. Pick up can arranged for either Clifton Hill or Reservoir.

Thanks,

Justin.

Picture419.jpg

Picture416.jpg

Picture422.jpg

Link to comment
https://www.sau.com.au/forums/topic/279151-fs-vic-hpi-savage-monster-truck/
Share on other sites

  • 2 weeks later...

PARTS SUPPLIED ARE:

truck

body(beaten up)

full radio gear(includes servo`s etc)- the antenna at the top is broken but it still extends to about 50 cm(new one is $19.95)

6 AA 2500mah rechargeable batteries(need another six, which from memory is $40) and a 1hr quick charger

glow plug igniter and charger

roto starter with a 2000mah rechargeable battery and charger

a tack box filled with dual stage filters, filter cleaner, thread lock, diff gears, slipper clutch and other miscellaneous parts.

all that is needed to get the truck running is 6AA batteries,fuel and a crown gear($15-20).

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
    • It's needed for rolling idle up, and I think it is a decider on VCT also.
    • I mean, not really. Link ECU's can absolutely still have errors from the ECU thinking it's getting a sensor it's not expecting. I would imagine the speed at the ECU level in Nistune does absolutely nothing anyway? I assume the ECU does not do any fancy TC stuff with regards to front+rear wheel speed or anything of that like anyway. Someone who uses Nistune may be more fluent in it. 
×
×
  • Create New...