Jump to content
SAU Community

Recommended Posts

I have up for sale a BRIDE BRIX 2 seat, its in neax perfect condition, has a couple small spots on the bottom,

1 about 1cm round and 2 about 2mm round so very small spots. no tears or any other defects. NO RAILS.

$600 or offers

i also have a

rb20 flywheel, $20 will post at your cost

R33 (i think) adjustable caster rods $60

2 x 35mm 5 x 114.3 bolt on spacers, brand new $120

Pick up Gold Coast. must be sold so i can run at jamboree

post-12049-1250128478_thumb.jpg

post-12049-1250128703_thumb.jpg

Edited by boostn32

Hey mate,

FYI that's not a Brix II... I believe it's a Brix I.

Also food for thought, the 1.5 is pretty much the same as yours pictured but has the Bride logo on the head rest...

Cheers,

Andy

I have up for sale a BRIDE BRIX 2 seat, its in neax perfect condition, has a couple small spots on the bottom,

1 about 1cm round and 2 about 2mm round so very small spots. no tears or any other defects. NO RAILS.

$600 or offers $500

i also have a

rb20 flywheel, $20 will post at your cost

R33 (i think) adjustable caster rods $60 now $50

2 x 35mm 5 x 114.3 bolt on spacers, brand new $120 now $100

Also have RB20 Radiator. $50

4 x alloy steering shaft spacers for S13 180SX R32 $26ea inc postage

Gold Coast. must be sold so i can run at jamboree

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, I'm back with bad news. There's no jack long enough on this planet that will reach the front subframe. If by some chance there is, it would weigh 200lb's.  I purchased a long reach jack... The damn thing weighted 120lb's and was massive. Didn't even come close, was still short at least a foot. It was a pain, but I brought it back. Next I decided HA! No problem, I'll get an Extra long reach jack. Well, I couldn't lift the box... It must have weighed 160LB's and luckily there was an open box in store. I took measurement and was still nowhere close.  Sadly I've lost hope and have accepted defeat. 
    • Thanks for that tip, niZmO_Man. I think the battery is OK. It's quite a new one, but I'll check. Last time I needed a new battery, everything electronic was fine, except that there wasn't enough current to turn over the starter. I decided to order one of the partial AV system translation CDs from Car Audio Workshop in NZ. That might have some effect, or help me diagnose the date problem. 🤞
    • I suppose it was relatively stock too, the JZ motor handle most mods thrown at them without even breaking a sweat 
    • I saw your intro update, are you sure you've actually had a starter motor failure? You mention it could be the alarm causing it. I'm assuming you've got a no start issue, but what are the exact symptoms, as there could be a few reasons it has stopped wanting to start.
×
×
  • Create New...