Jump to content
SAU Community

Recommended Posts

i know its kind of obvious but it sounds like you might have blown a fuse. check all the fuses and if they are all fine then you may have a short somewhere in your wiring. you may have to rip out most of the dash to find it but hopefully its just at the back of your head unit somewhere.

i just fixed up my mates stuffup with installing his headunit and sub. he didnt solder any wires and he missed a few all together. make sure any wires you dont find a use for get some electrical tape around the ends to stop them shorting on anything.

The Clock Died whilst connecting the Wires to the New Head Unit. Has this happend to anyone else? also the Air Conditioning Contols have Died. Cant figure out What happend. Need Help

it`s a 10amp fuse you have earthed power wire at some time during installation

have done it once or twice my self

yep...i did the same just recently..was using my pocket knife to slice some elec tape on the constant power line. Fried the clock.....15amp fuse

it`s a 10amp fuse  you have earthed power wire at some time during installation

have done it once or twice my self

  • 4 weeks later...
How difficult is the Stock R32 headunit to remove in a GTR? Is is similar to the R33 headunit guide posted in this forum?

R32 is pretty much straight froward

1. pull up the gear boot plastic trim and take out the ash tray there should be 4 screws 2 behind the ash tray and 2 under the shifter boot

2. then the surround peice should come off

3. there is a bracket holding the HU in 6 screws hold this in, 3 on each side

4. the whole lot should slide out and thats it

i can take pics but mine will be a litle bit different because i have modified my dash

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sane enough. Remove the roof liner, because the acid will go everywhere.
    • Thanks guys, I really appreciate the help and experienced opinions.  I have spent a lot of my life working on boats so I'm pretty good with fibreglass. I'll take everybody's advice in here;  I'll cut a little more of the 2nd layer away as it's a bit crunchy rust and also it's sitting high now. Then I'll wire brush it all a bit to get off anything loose, then I'll soak the bejesus out of it all in rust converter. I'll make sure to get a little hose piece and feed it into all the holes and gaps between the roof layers. Then I'll fibreglass up the holes.  Then I'll get a pallet of filler and mix it with 3 buckets of hardener and hope that is enough to build up the roof corner.  Does that sound sane? Is one type of filler better than others for this?
    • My goals for it atm are to get it registered, respray and some mild power gains eventually... I picked up the car from an elderly gentleman near the border of NSW and VIC, its honestly a bit rough and looks like its been driven on a farm (because there was so much dirt underneath). Last week I dropped the subframe and emptied the old fuel out + added a new fuel pump (think the old one went bad from old fuel). Now I'm onto fixing a coolant leak at the rear of the engine + adding a new radiator as the old one is corroded. After that i have a new bumper, coils (as the old were leaking) and lots more
    • Welcome buddy! Plenty on here and YouTube. What are your plans for it? Good luck with the Rwc and Rego bud!
    • Love this so much! Please post a photo when you have a bike on the trailer.  I was a little bit worried about having a tow bar on the Skyline, but having it hidden behind the number plate is genius
×
×
  • Create New...