Jump to content
SAU Community

Recommended Posts

http://www.rtsengineering.com.au/

There ya go Luke

And Pete im currently on the hunt for a stock one but seems very hard to find as no one is selling.

So many little things i need to get it running, but it all adds up.

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

http://www.rtsengineering.com.au/

There ya go Luke

And Pete im currently on the hunt for a stock one but seems very hard to find as no one is selling.

So many little things i need to get it running, but it all adds up.

Thank you muchly :happy:

Arr damm. Pretty sure i'll have a 1.5K genuine nissan bill soon for everything i need.

Send me a PM of the part numbers, I'll see what I can do through my hookups at Lakeside and see if I can get it any cheaper for ya

Any idea if Z32 AFM's work with a stock computer?

What AFM's have u got in your car Luke?

you will need to have the ECU tuned for them, you can't just plug them in a drive as they have a VQ map to the factory AFM's

Edited by D_Stirls

Heaps of people selling brand newys in the FS section at decent prices, make their f**kup your gain otherwise Bosch?

*post directed to Dohmar*

Edited by Weezy
wheres the best place to get guages ?

need oil pressure gauge asap , i want one to match my greddy boost gauge but i think they are about $200 :happy:

gaugeworks

i went there to get a psi mechanical based boost gauge to fit in my car, goes to 25psi and does vaccum aswell, even uses standard globes which meant i could use the led's from 666dan. Got the mechanical oil pressure gauge too. Both are made by vdo and look quite nice, and they suit the general font and display of the r32 gauges. sample pic below. Oil pressure on the right

DSC00251.JPG

-D

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...