Jump to content
SAU Community

Recommended Posts

Originally posted by adam 32

what do you mean prime the fuel lines??

and my fuel economy is ****!!! but i guess its all part of the same problem.... AF's are hovering around the 10:1 mark

Your AFs are not helped by that Blitz ECU of yours; I assume it aint tuned for australian el'crapo fuels, aggressive maps aside.

Go buy an e-manage.

Go buy a fuel regulator. :D

Just switch the key to on and the pump will pressurise the line, you should be able to heart the pump work then stop, then you can start the car.

The new pump will have more pressure so when the other would not pump enough at high revs this one will be consistent, get it remapped and it will be fine.

if you had your car running fine before installing this pump,then i think youve done something that you shouldnt of.

The pump itself should be ok if that was the only thing installed.

Even if higher flow,the regulator is the part that controles the amount of fuel pressure your injectors will see,and will keep it at a constant 40-45psi at idle.

unless your regulator is faulty,it could raise the pressure and make it run richer(but you havent touched it,have you?).

Best thing to do is,put a fuel pressure gauge in line with your fuel out hose and see how much PSI your getting,and let us know.

Have you connected everything properly?(in -out lines)

once started,can you rev it and keep it idling

explane a bit more...

once started the car runs like an absolute gun!

no idling or fuelling problems at all

its just on start up that it wont start straight away, you turn the ignition and it ticks over for about 5 seconds then fires......

i know i need a remap as well but i cant afford it now as i just spent it all on the pump and a boost controller!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...