Jump to content
SAU Community

Recommended Posts

  • 3 months later...

I don't think there is any calibration as such? The sensor senses how far open it is and feeds the signal to the ECU as far as I know.

Adjusting your cable is another story. Take out the slack, and you could use a consult cable and software to confirm WOT. (with the car ignition on, but not running)

Link to comment
https://www.sau.com.au/forums/topic/313610-calibrate-tps/#findComment-5356473
Share on other sites

what i mean about calibration is so the tps is sending the right signals to the ecu cause at the moment i think the tps is out of its right position, meaning that is prob sending a signal that the throttle is like 5% open when its actually closed.

i just want to know how to set the tps back to the right position so its like 0% thorttle and the ecu is actually reading 0% thorttle

get me?

Link to comment
https://www.sau.com.au/forums/topic/313610-calibrate-tps/#findComment-5357117
Share on other sites

  • 2 weeks later...
there has to be another way, like using a voltimeter using the resistants on it etc etc

It can be done that way, you will need to find out the correct voltage for it (EG: the 300zx tps is set to 0.45v at 0%) the easiest way to do it is to find the correct voltage for closed throttle and then get a multi metre in there and set it to it. If you have someone with either a consult cable or an ecutalk lcd display this can be done easily (5 mins)

Edited by RandomHero83
Link to comment
https://www.sau.com.au/forums/topic/313610-calibrate-tps/#findComment-5379118
Share on other sites

yeah you can just use a multimeter to check the voltage. the voltage should be around 0.45v when closed. this is pretty standard for a lot of nissans. pretty sure the sr20 is also the same. there will always be a slight variance though. i'm not sure exactly what the allowable margin is, but if yours is dramatically different then i'd have a play around with it. if i get time i'll have a look through some stuff i have and see if it says.

Link to comment
https://www.sau.com.au/forums/topic/313610-calibrate-tps/#findComment-5379290
Share on other sites

  • 2 months later...
what i mean about calibration is so the tps is sending the right signals to the ecu cause at the moment i think the tps is out of its right position, meaning that is prob sending a signal that the throttle is like 5% open when its actually closed.

i just want to know how to set the tps back to the right position so its like 0% thorttle and the ecu is actually reading 0% thorttle

get me?

Sorry for dig up this topic, hopefully i'm in the right place to post my problem. Currently my car(bnr34) MFD show the throttle reading at 1-2% when idle, for what I know it should be 0% when idle, I pop-up my bonnet and check the stop-screw, it is backed off without touching the throttle linkage(1mm gap), but why the reading show 1-2% when idle? Will TPS cause the MFD throttle reading like this?

Link to comment
https://www.sau.com.au/forums/topic/313610-calibrate-tps/#findComment-5501997
Share on other sites

your MFD is probably guessing what '0%' means. e.g. if it has decided 0.44v is 0%, then if its reading 0.46v then it will show as 1-2%. maybe there is a setting in the MFD to calibrate the 0/100% throttle voltages?

Link to comment
https://www.sau.com.au/forums/topic/313610-calibrate-tps/#findComment-5505120
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...