Jump to content
SAU Community

Recommended Posts

This is an amazing setup that I had in my sil80. Makes 277RWKW on one bar (14.7psi) boost and 312RWKW on 19.7psi. The boost set up is 3 stage via Eboost controller allowing for different power for different applications. The car comes on boost 2500rpm and makes full boost at 3700rpm with a very steap power curve pulling all the way through the rev range. Everything is controlled via An Apexi Powere FC and can be monitored and changed with the handcontroller. The oil is helped kept at a health temp with the oil cooler. The motor is near new with only 2500km on it. It is all ready to go, just put in ur car and drive. No tuning needed or anything. Ive spent well over $28,000 on this awsome setup!

Selling the whole set up for $11,700

Ryan 0438504324

Internals

- Sr20det

- Hot wash parts

- Bore and Hone block

- Polish crank

- Hone small ends to suit pins

- Surface grind block and head

- New valve guides and plugs

- Balanced engine assembly

- ACL RS mains and big ends

- CP forged pistons 20thou

- CP forged rings

- Eagle Rods

- Poncams 256deg with 11.5mm lift

- Eagle Rods

- Tomei 1.7mm Metal Head gasket

- Tomei rol lon timming chain

- TOMEI Rocker Arm Stoppers

- ARP Head Studs

- ARP Rod Bolts

$10,800

Engine Hardware

- GT3076 Dual ball bearing turbo $1,800

- Braided oil and water lines $287

- Custom steam pipe Exhaust Manifold $1,700

- 50mm Waste gate $200

- Screamer

- Custom stainless steel dump pipe $300

- Oil cooler with remote filter location $429

- Braided lines to oil cooler

- Apexi Power FC $1,500

- Apexi hand controller

- Splitfire direct ignition coil packs $600

- 600cc top fed injectors with high flow filters$800

- Custom fuel rail $380

- Rising rate fuel pressure regulator $160

- Z32 air flow meter $300

- Custom stainless 4" intake $80

- Drift high flow pod filter $60

- Triple plate Osgeiken clutch $3,500

- Resprayed Rocker Cover in Blue

- Full SR20det s13 Wireing loom set up ready to go

- Eboost boost controller $580

- Gearbox $700

- Tune by Matty Spry at PITS $1,600

TOTAL $25,776 + thousands in labour

sr20rebuild009-2.jpg

sr20rebuild001-2.jpg

sr20rebuild002.jpg

sr20rebuild003.jpg

sr20rebuild006-1.jpg

sr20rebuild007-2.jpg

sr20rebuild011-2.jpg

sr20rebuild013-2.jpg

sr20rebuild014.jpg

sr20rebuild001-1.jpg

sr20rebuild007-1.jpg

sr20rebuild008-1.jpg

sr20rebuild011-1.jpg

sr20rebuild012.jpg

DSC01101.jpg

DSC01102.jpg

DSC01103.jpg

DSC01104.jpg

DSC01105.jpg

DSC01108.jpg

DSC01111.jpg

DSC01189.jpg

DSC01183.jpg

DSC01186.jpg

Link to comment
https://www.sau.com.au/forums/topic/313641-3oorwkw-sr20det-motor-set-up/
Share on other sites

Hey mate,

I'm interested, but i'm about to head off o/s for a few months for work. If you still haven't sold it by then i'll probably be able to take it off your hands.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • BRUH, one of the biggest mistakes of my life..... and i've had plenty ;[)
    • @Murray_Calavera iam just considering options 🙂 of course it is very expensive so that why i ask here 🙂  @joshuaho96 I looked at that GCG hybrid(i remember looking at it few weeks before) So this is "that" hybrid where i send them my turbo and they upgrade the inside to Garrett stuff and then they send it back. It cost around 1200-1300 USD which is FAR cheaper than the HKS and it is what iam looking for(i just do not have experience like this...to send something off to "upgrade" ) @tylink720 that is like 150 USD turbo no? 😄 I dont think i have the "ease on my mind" with this kind of turbo. I just put over 7000k USD to "LINK" up my engine...dont want to blow it up with cheap turbo 😄     EDIT: https://www.cj-motor.com/gcg-turbo-charger-for-nissan-rb20det-rb25det-high?srsltid=AfmBOooVeOZ6CZ6r1AIv5m-KPaa6BvudIPJTY8LW78khkd-gQlsaCht9 I looked at this and it seems ok? It is that CGC hybrid and it costs around 1250 USD (with back shipping). Do any of you have experience with this hybrid on NEO turbo? I quickly look thru the forum/web and it seems very good.
    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • It's funny, as Ive seen plenty of people use them in cheap builds on YT. And they actually go okay, even though a lot of other maxspeedingrods stuff is terrible. Those turbos seem reliable enough, the only part being, a good quality turbo that is "identical" to it, will out perform it day in and day out. In both a lower boost threshold, and the ability to flow more air at the same boost pressure. As a cheap cheap replacement, not a terrible choice. For cheap and shouldn't blow in a day, not terrible (like other eBay/Temu turbos) for low cost and still decent performance, that's where the question comes in to play from the results I've seen. I'd actually find it hilarious to buy one, and strap it to a paddock basher or some other cheap as POS originally NA car, and send it to the moon!
×
×
  • Create New...