Jump to content
SAU Community

Recommended Posts

Hey guys, due to financial reasons we've decided to get rid of our mkiv supra.

We need to get rid of it to pay off the rest of the loan due to being very broke lol.

The car is almost completely unmolested except for 18"rims and stereo system

and is my girlfriends daily driver as she can't drive a manual :-).

Car:1993 Toyota Supra

Location:Sunnybank Hills, Brisbane

Colour:Black

Trans:Auto

Engine:2jz-ge (NA)

Km's:165,xxx

Other:

Positives:

Has a set of 18" rims with 2 rear tires needed due to an earlier camber problem. Have receipt if needed.

Fronts 225/45/18 rear 264/35/18. Also has a pioneer mp3 head unit and alpine type-r speakers

front and back. Only serviced 2000km ago.

Negatives:

I assume the o2 sensor is on its way out as the engine light comes on when slowing down but goes off

when you start accelerating again.

The drivers side power seat stopped moving forward but seat is as far back as it goes and is still easy for my gf to drive.

Has a foot long scrape on the passanger side rear quarter from the mirror on my civic when she reversed out and didn't

see it.

price: $15,000 ono

She paid just under $20K for it a 2 years ago at an importers in slacks creek.

The car drives perfectly and handles well due to the larger tires. Perfect for a p-plater to pass the time on and still be

driving a nice car. The car currently has my rx7's 18's on the back but will come with the pair to match the front.

Will be sold as is, with no rwc as we don't have the money to replace the tires etc. Car is registered till some time

during june and will be sold with rego still on it. Car is driven daily and can be inspected and test driven upon

request. Any other info needed? Just pm me.

Will try to get some pics before the weekend.

Link to comment
https://www.sau.com.au/forums/topic/315560-fs-mkiv-supra-na-auto/
Share on other sites

bump.

going panel beaters to get scratches and scrape removed next week and had the scan tool put on and it reads no fault codes. the mechanic said it may be faulty brake fluid level sensor as they are apparently a common problem.

bump.

have a set of bilstein coilovers going in next weekend and faulty brake fluid level sensor replaced. car will now also be sold with a rwc too.



  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...