Jump to content
SAU Community

Clifford Avantguard 4 And Aust Stds

wazza_34

By wazza_34,
in Car Audio & Electrical

 Share

Recommended Posts

wazza_34 Rookie

wazza_34

Posted
Posted

Hi everyone,

Does anyone know whether the Clifford Avantguard 4 alarm/immobiliser complies to australian standards. I ask this because i imported the car with it already installed and wanted to know if it is ok for Justcars.

Also, has anyone had experience with this alarm? is it any good?

Thanks in advance.

Link to comment
https://www.sau.com.au/forums/topic/320269-clifford-avantguard-4-and-aust-stds/
Share on other sites
danielr34 Collaborator

danielr34

Posted
Posted

Clifford make reasonable security systems and usually comply to UK standards or Thatcham Approved, I am not too sure if they have been put through the Australian Standards Testing procedure however, even if they have all the features of an Australian Standards alarm system ie black wiring, 3 point immobiliser etc does not mean they would be covered by insurance. Being that they are not sold here in Australia (that I know of) I would say they have not been tested for AU Standards. In the past I have had to remove a few Clifford alarms from imports in order to fit an AU Spec immobiliser.

Sorry can't give you a definate answer, only what I have seen in my experience.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      boost source Size Garrett gt28 gen2

      By GTSBoy · Posted

      If there's enough meat in the housing where you want to put the M12 adapter, then do it, but be aware that if/when you f**k that up you'll probably be repairing it before doing anything else. I'd just drill it out and tap ina 1/4" thread. No need for rocket surgery when the next most obvious thing will do. You could throw a 1/4 x 1/8 bush in there and use the same fitting you intended to use.
    • GTSBoy
      RB26DETT Sketchy boost mod?

      By GTSBoy · Posted

      Not this But this  
    • Murray_Calavera
      What should I do next to hold the head on

      By Murray_Calavera · Posted

      Is the only issue that the oil catch can is getting filled on hard runs? I'd be thinking more about oil control issues rather then the head lifting, especially as you aren't seeing spiking in the coolant pressure.  Do you need restrictors in the head, or better drains from the head? Does the sump need venting to the catch can?
    • timmy94
      boost source Size Garrett gt28 gen2

      By timmy94 · Posted

      Tried to make 1/8npt threads into compressor house of the turbo for my EBC. Threads got fu#ked and ended up with and elongated hole, so I do have good amount and nice threads 90% of the hole but 10% I only had 1-2threads there and rest of it is flush on that side of the hole.. So my idea is to do M12 x 1.25 to AN4 with braided lines instead of 1/8npt to 4mm vacuum silicone hose.  and hopefully get a better thread. M12 is quite big and AN4 is a little bit bigger than 4mm (4.9mm inner diameter braided PTFE hose). but this should work. Thoughts? Otherwise I will weld and adapter onto the turbo.   
    • Duncan
      C34 RSFour V Build in the US

      By Duncan · Posted

      Looks great, I hope everything is working well after all that time!
×
×
  • Create New...