Jump to content
SAU Community

Recommended Posts

i have a r32 rb20det car started on thursday tryed startin it on saturday wont start turns over and allmost starts then dies thought it was a fuel problem took off one of the fuel lines that goes in the injector rail and turned the intion on car pumped fuel fine any one no what it could be

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/
Share on other sites

dose it jump start ok ???? if so check the charge rate on the battery with a multi meter. It should read read about 13.7 volts with all accessories on and lights. Than charge the battery and test it if is stuff could have a dead cell in the battery

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/#findComment-5236426
Share on other sites

Do you have a multi meter. If so check the voltage drop on the battery it shouldn't drop below 9.5 volts. if thats ok check the voltage drop onto the starter motor itself by testing the voltage at the starter main power feed wire and the earth on the battery. It could be as simple as a lose earth or power cable.

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/#findComment-5236446
Share on other sites

Yeah it could be that just pull a coil pack out with a plug in it and turn it over to see if you have spark. But if it dose not crank easily i be leaning towards the electrical side of things with the starter motor.

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/#findComment-5236453
Share on other sites

checked my car today still couldnt get it to start its poping a fuse under the dash the top right second to the end fuse its a 15amp fuse it says its an acc fuse does any one no where this fuse goes or if it would be stopin me from startin my car i checked all the wires and taped up all the dogey wires hasnt helped all plus swap the inighter pack over with another one that i know works wasnt that

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/#findComment-5237431
Share on other sites

yes you need a tool called a noid light i dont know if thats how you spell it to see if the injectors are getting a signal or you can use a automotive stethoscope and listen to the injectors themselves to see if they are firing.

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/#findComment-5237834
Share on other sites

Ohh sorry i meant Beagle!, i had a similar problem but i was converting my s13 from ca18de auto to rb20det manual, and had no spark of injector pulse turned out to be a faulty loom, but i highly doubt it because ur car is stock and untouched well the loom is. so my next suggestion is get a mate with a 32 and swap cas over, that will control spark and injectors

Link to comment
https://www.sau.com.au/forums/topic/320877-car-wont-start/#findComment-5245623
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...