Jump to content
SAU Community

Recommended Posts

Following items for sale in new and used conition as shown.

To suit R33, R34GTR:

Used condition, Apexi Pod filter and adapter kit, suit 60mm AFMs, includes brackets. $200

To suit R32GTR etc:

Used condition, front upper camber lh+rh arms stock in good condition, bushes are good!. $100

Used, Front left drive shaft with inner CV, axle good. $20

Used, front stock lh+rh brake cooling plastic guides, one has a bit missing off the front-side but still useable. $40

Used, front standard undertray, has a lh tab missing. $50

Used, alternator, requires rebuild and new regulator etc as it doesn't work. $20

Used, HKS pod filter 80mm inlet I think, $10

Used, HKS F-con v computer with loom, needs a denso 3bar map sensor (tune in computer was for 2530's, 260deg pomcams and 700cc injectors etc). $200

Used, GTR cams, factory standard in good condition, inlet and exhaust. $200

New, Lh front steering tie rod, never used. $20

Used, R32GTR gearbox, suspect broken 3rd gear, was rebuilt with new bearings and synchros before 3rd gear went, would need new gear set, no xfer case. $200

Used, front seat belt seat mounted restraints x2. work fine. $20 pair

Used R32 gear shifter surround in black. $20

Used, LH rear drive shaft assy complete, in good condition. $100

Used, GTR gearbox housings, bell housing and main housing, good condition. $30

Used, R32GTR stainless steel exhaust exhaust, turbo back with cat, resonator, muffler and delete pipe, 3.5Inch system. $250

post-12712-1275894310_thumb.jpgpost-12712-1275894371_thumb.jpg

post-12712-1275894442_thumb.jpg

post-12712-1275894607_thumb.jpgpost-12712-1275894646_thumb.jpg

post-12712-1275894698_thumb.jpg

post-12712-1275894775_thumb.jpgpost-12712-1275894923_thumb.jpg

post-12712-1275894947_thumb.jpg

post-12712-1275895045_thumb.jpgpost-12712-1275895083_thumb.jpg

post-12712-1275895316_thumb.jpg

post-12712-1275895350_thumb.jpgpost-12712-1275895384_thumb.jpg

post-12712-1275895430_thumb.jpg

PM if interested.

Postage of smaller items can be arranged with postage added to item price.

Pick up of larger items prefered.

Located at RAAF Richmond NSW 2755

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/323910-the-bits-and-pieces-sale/
Share on other sites

very much interested in teh undertray. When would be a good time to come and have a looky over the next week or so? Monday possibly?

Pm's replied.

Items remaining:

Apexi pod filter setup

undertray

LH rear driveshaft assy

Cams

belt buckle

alternator

pod filter

upper camber arms

gearbox

gearbox case

  • 2 weeks later...
  • 3 weeks later...
Following items for sale in new and used conition as shown.

To suit R33, R34GTR:

Used condition, Apexi Pod filter and adapter kit, suit 60mm AFMs, includes brackets. $100

To suit R32GTR etc:

Used condition, front upper camber lh+rh arms stock in good condition, bushes are good!. $50

Used, Front left drive shaft with inner CV, axle good. $20

Used, alternator, requires rebuild and new regulator etc as it doesn't work. $20

Used, HKS pod filter 80mm inlet I think, $10

Used, GTR cams, factory standard in good condition, inlet and exhaust. $100

Used, R32GTR gearbox, suspect broken 3rd gear, was rebuilt with new bearings and synchros before 3rd gear went, would need new gear set, no xfer case. $150

Used, front seat belt seat mounted restraints x2. work fine. $20 pair

Used, LH rear drive shaft assy complete, in good condition. $60

Used, GTR gearbox housings, bell housing and main housing, good condition. $20

PM if interested.

Postage of smaller items can be arranged with postage added to item price.

Pick up of larger items prefered.

Located at RAAF Richmond NSW 2755

Cheers.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
    • Forgot to include this but this is the mid section of my steering rack that looks like it has a thread/can be turned with that notch mentioned in the post:
    • Hey everyone, Wanted to pick some brains about this issue I'm having with rebuilding my 33 rack (PN is 49001-19U05). All of the tutorials/videos I've seen online are either R34 or S Chassis racks which seem to be pretty straightforward to disassemble but this process doesnt carry over to my rack. Few of the key differences that I've noted The pinion shaft on the other racks bolt on with 3 torx bolts: Whereas my rack bolts on with 2 allen head bolts: These changes are pretty inconsequential but the main difference is how you pull the actual rack out of the housing. The other skyline/s chassis racks can be taken out by tapping the rack out of the body with a socket and it just slides right out. I'm unable to do that with my rack because there's a hard stop at the end that doesn't let the seal/shaft be tapped out. Can also see a difference in the other end of the rack where mine has a notch that looks like you're able to use a big wrench to unthread 2 halves of the rack whereas the other racks are just kinda set in with a punch. My rack: Other racks: TLDR; Wanted to know if anyone has rebuilt this specific model of steering rack for the R33 and if there were any steps to getting it done easier or if I should just give this to a professional to get done. Sorry if this post is a bit messy, first one I've done.
    • I would just put EBC back on the "I would not use their stuff" pile and move on.
×
×
  • Create New...