Jump to content
SAU Community

Recommended Posts

do you have an aftermarket oil pressure guage installed? If so it may be a capillary line type that carries engine oil to the rear of the guage and may be leaking. Alternatively your engine maybe leaking a substantial amount of oil that has built up on the firewall and is making its way through a grommet then onto your pedal box. Start lookin at the rear of the engine bay for answers.

Link to comment
https://www.sau.com.au/forums/topic/33104-oil-on-clutch/#findComment-663983
Share on other sites

You may find that the clutch master cylinder piston is on the way out and leaking past the seal, I've had this happen to me before.

Lucky you don't have oil on the clutch plate, my mate had an oil line break and spray oil over the clutch, now it's the most horrible sounding button clutch you've ever heard :P

Link to comment
https://www.sau.com.au/forums/topic/33104-oil-on-clutch/#findComment-664069
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...