Jump to content
SAU Community

Up Comming Wedding

Cam84

By Cam84,
in New South Wales

 Share

Recommended Posts

Cam84 Community Regular

Cam84

Posted
Posted

Hi guys

Ok, the day seems to be getting very close very fast. Just putting the call back out there as I will need to start booking things in.

Basically,

I'm getting married in November, at the Sir Fransis Drake at Heatherbrae near Newcastle, looking for any GT-R as long as it's tidy. Would prefere R34 but i know there few and far between in Newcastle so any will do.

Looking at 3 cars with two passangers each.

There will be about 30-45mins max driving the whole day as i live local (not including your own travel time). so it's basicly pick me up at my house(Thornton) drive about 10mins, have the ceremony than drive to the local river for some shots and back again.

you will get paid, but price would have to be worked out.

Cheers guys

Cam

Cam

Link to comment
https://www.sau.com.au/forums/topic/334645-up-comming-wedding/
Share on other sites
  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • MBS206
      R32 update from 1990's spec.

      By MBS206 · Posted

      With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • joshuaho96
      RB26DETT Sketchy boost mod?

      By joshuaho96 · Posted

      This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...