Jump to content
SAU Community

Recommended Posts

Hey Guys, just got my car (r33 gts-t) recently serviced from a different service place to my normal place and they have done a pretty shitty job! anyways, i got the car back home and then it wouldnt start once it got warm and i could smell electrical wire burning, once i opend the bonnet, i saw what the issue was, the wire harness the connects to the oxygen sensor on the downpipe had come off a table tie and was sitting on top of the turbo and it had melted it nicey all the way through, anyway i called the service people, they came down and swapped the plug over, (however not an original R33 wire clip) and it all seems fine etc

So today was the first day i took it for a proper spin and it was all good until i hit the freeway, i was driving along fine for around 10 mins then and accelerated to around 120 and i felt like the engine just died and dropped power and even though i was holding onto throttle, the power was dropping, the strange thing was there was no stuttering or missing(which you would get with coil packs/spark plug issues) it just felt like i lifted off the power but i was still accelerating. it was really strange. I took the next exit and it was running fine after that, and was reving without any problems. This has never happend before and i was wondering what the issue could be? could be be related to a dodgy job on the repalcement oxy sensor? The service guys changed the spark plugs could this be a issue? i am a bit lost

what the service guys changed

engine oil

transmission oil (car is auto)

spark plugs (platinum)

most of the blets like fan belt etc

sorry about the long write up, but all feedback much appreciated so i can get to the bottom of it

thanks guys,

Din

Link to comment
https://www.sau.com.au/forums/topic/337171-advice-opinions-needed/
Share on other sites

sounds like a fuel pressure issue - what you describe is the same as when you get fuel surge or run out of fuel

didn't even think of that! could be one of the reasons!

i was also thinking, maybe its the coil packs in the early stages of dying? i have had them for a long time and since they changed the spark plugs, they are making the coil packs work a lot harder and it only happend at constant high revs when the car had warmed up. hmmm.

didn't even think of that! could be one of the reasons!

i was also thinking, maybe its the coil packs in the early stages of dying? i have had them for a long time and since they changed the spark plugs, they are making the coil packs work a lot harder and it only happend at constant high revs when the car had warmed up. hmmm.

could try regapping them to 0.8mm

but if the engine is revving higher, but no acceleration - sounds like fuel issue

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
    • Does the scanner do all the CUs in the car, or only the ECU?
    • @666DAN sorry to bring you and old thread.     I've got my de+t done and it's all running great other than 1 small issue.    Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd when selected . But nothing when in  drive or what gear your in when you pop it into tiptronic. I'm sure there is maybe 1 wire in the ecu plug I need to move to rectify this. Do ya have any ideas?     Cheers man
    • Well I recently changed my rear axles and was thinking if I bumped anything, I have been driving the car for a while now though... But it has been raining today so everything is wet under the wheel arches. Brakes feel fine and can't hear any of the metal screamers, I had a squeak coming from one of the handbrake drums but that seems to have gone away a while ago. I was going down a hill when it lit up and I did feel the abs bite for a second and question why it did it?
×
×
  • Create New...