Jump to content
SAU Community

Recommended Posts

I just block my base off...... its a noobalishous way but its all i cbf doing. Being terran is fine as you can drop your supply depot to get out. Normally block with 1 x depot, 1 x barracks and bunker.

Im just a mass marine medic whore, with a dash of marauders, siege tanks & vikings.... that combo seems to do well most of the time.

But take no advise from me, i am a bronze league bandit ROFL

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

Zerg get their queen though which is a buff as f**k unit in the early stages.

yea but, to get it, you goto make a spawning pool, then actualy process the queen, by that time they already have zergs on the way since their quicker to make, no to mention less resources, 150 minerals is a lot in the early stages

I've never been beaten by a 6 pool as a Zerg player. The key is to scout early when going against zerg/random and assess whether or not to get an early spawning pool yourself.

Remember you have that extra time it takes them to run across the map, and if they do get there early just run your drones around the hatchery. Without speed those lings will be lucky to kill 2 drones before your lings/queen/spinecrawler are ready.

The real problem begins when they 6 pool you AND send a drone across to build a spinecrawler in your base, that's always fun but easily countered if you're quick with your own drones to kill it.

ash, fix your msn, msgd u a couple of times, no answer

fix it fix it fix it fix it

I know - Hardly been home past 4-5 days (just had a bucks w/e on and stuff).

I'll be around this week, 10pm or later as im working arvo, but ye should be on a couple nights at least

I know - Hardly been home past 4-5 days (just had a bucks w/e on and stuff).

I'll be around this week, 10pm or later as im working arvo, but ye should be on a couple nights at least

sweet, 10pm, will have a quick game before ni niez, will get alex on to, we'll have a 3 way... wait what?

Add me im keen as i dont play it much cuz i have no one to play it with! User name SusCraft

Protoss FTW!!

if u have msn ad me, my addy is a page back or so?

hopefuly my net is better soon, its absolute garbage atm

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...