Jump to content
SAU Community

Head Light Problems.

pasteyy

By pasteyy,
in General Maintenance

 Share

Recommended Posts

pasteyy Apprentice

pasteyy

Posted
Posted

Ok well i got a new light about a month ago and put it in but didnt do it propelly as i coulldnt be bothered. Last night i started to take the head light out as it came out the earth wire started dangling around. But the thing is im not to sure were the earth was actually wired theres no terminal for it ethier if you know what im trying to say. Ill probably check my fuses sometime today and get some wiring to make a new earth but could there be any other reason this could of happened? Also even when you put onto high beam the light still dosent work.

Oh i have an r32 gte aswell. with r32 gtst lights im pretty sure.

Link to comment
https://www.sau.com.au/forums/topic/341519-head-light-problems/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      Like I said, "black magic" LOL In the end,  it is what it is, and hopefully, what this here knuckle head has done is an improvement and not a hindrance Not that I actually notice any negatives now, or that I will get any seat of the pants benefits when all is said and done, but best practice says I shouldn't be pulling intake air from the hot engine bay  Famous last words: I cannot see it being any worse than what it is at the moment 🤔
    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      If the gases flowing in those two tracts had the same properties, you could maybe use such broscience. But the exhaust has a different composition, different normal density, different actual density (because of different normal density, and mostly because of the massively higher temperature), and different viscosity (again because of much higher temperature). Consequently, all of the fluid dynamics parameters that matter, that you calculate from these inputs, such as the Reynolds number, friction factors (for wall friction) and so on, are all incomparable.
    • GTSBoy
      Ethanol Content Sensor - Always at 11%?

      By GTSBoy · Posted

      And we shall have to presume that Canada is the same?
    • joshuaho96
      Ethanol Content Sensor - Always at 11%?

      By joshuaho96 · Posted

      In the US almost everything is E10. It can't exceed 10% by much or fuel systems have trouble adapting. At the same time because MTBE, MMT, and TEL are all banned they need as much ethanol in it as possible to boost octane.
    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      I was mostly jesting. In my experience (and probably only my experience) the R34 GTT physical airbox space is actually too small to flow the amount of power it wanted. By sealing the box, I made it so it could only be fed by the ducts themselves. So you can seal it up and get nice cold air which IS good, but at a certain crossover point: More Hot Air > Less Cold Air I don't think you're at this point. In my case merely ducting the hot air intake with a very focused set of ducts counteracts the fact it's in a V8 engine bay. More cold air obviously best. The solution looks great.
×
×
  • Create New...