Jump to content
SAU Community

Recommended Posts

Hey all,

I recently followed the AAC clean tutorial and Air Reg clean tutorial on here and now i've run into some problems!

After completing both and putting everything back in the car i had high idle/reving.

Car was also shaking alot and when i took the car for a drive i had no power and car wouldn't go.

The idle issue has been fixed now but i still have the problem where the car is shaking like a mofo and i suspect a lost cylinder or something along the line.

I only thing i took off and touched was the throttle body, AAC and Air Reg so i can't understand why i would have these issues.

Anyone able to give me some advice?

Thanks.

Link to comment
https://www.sau.com.au/forums/topic/349255-lost-cylinder/
Share on other sites

hey guys,

after some investigating it seems engine/cylinder 6 is not running.

At first when i pulled out spark plug it was wet!

so i swapped over a new spark plug. It fixed it for like 30mins and then i had issues again.

this time i pulled out sparkie it was dry... i checked all other sparks and they are fine as well.

so i did the test where i pull the plug off each coil pack 1 by one and see if engine reacts.

all cylinders react except for #6!

i swapped the coil pack with #1 but its still the same.

so i can rule out spark plug and coil pack. i'm pretty sure i can rule out injector? as it made the spark plug wet the first time?

so what else could be the issue?

any advice on what else i can check would be great!

thanks.

Link to comment
https://www.sau.com.au/forums/topic/349255-lost-cylinder/#findComment-5614905
Share on other sites

If you have a multimeter, try probing a working cylinder to see what the normal output is to its coil plug, then try 6th coil plug and compare the 2, it might not be getting power/spark/whatever to it

Link to comment
https://www.sau.com.au/forums/topic/349255-lost-cylinder/#findComment-5615222
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...