Jump to content
SAU Community

Recommended Posts

As some of you know I have a s-afc on my 32 and it seems to be working fine at part throttle tune. However at full throttle I am leaning out at max power then richening up near the end (wrong way around) the thing is that we maxed out the afc at this point and made no difference. Then we backed it right off and made no difference to the dyno run???? What could be causing this? afm is 99.6% maxed out but injectors are good and the fuel pump is huge so whats the prob?

Anyone

have you checked your throttle postions the default is 15% may be change it if the afm is maxing out may be a fcd needed as the ecu cant make change cause the figure is constant.?

just thoughts not fact.

you afm seems to be the issue cause its maxing out so the ecu just dumps fuel.

meggala

The thing is this, I want to fit bigger injectors so if I do this the afm will not be on as much load so what I will do is get my car running as good as possible with this setup then buy 6 550cc rx? injectors for $420 and this will solve all my problems as the afc will then be used to BACK the fuel off instead of add it, my tuner has estimated the afm to be at approx 66-70% with these injectors as he has done similar things on other cars. My main goal is to run a this years Jamboree in September with a mid-low 12sec.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oof. One of my mates has an R34 GT-R that he initially was a "I want to go twins for response and convenience" on his stock 2.6 with Kelford 272 cams, but his friends are pests and were always in his ear about their place being in the bin.   Eventually one of the 2860-5s decided to add it's own input and force his hand, so he conceded and went for a Pulsar 6262G ("G35 900") with T4 0.85 hotside.    Here's an overlay of the results, same cams, same stock bottom end, same boost, same fuel, just from a pretty tidy 2860-5 install to a Pulsar turbo on a 6boost maniifold on BP98.   Worth mentioning here, it may seem like a dead horse thing but the dyno plot doesn't tell the story of how much better it is to drive - transient response has completely changed the car, he used to have flat foot shifting to stop it having to wind up again on gear changes even at >7000rpm... now it builds boost faster than that even short shifting.   It's 100% transformed the car before you even consider how much better it holds on: Pulsar and Garrett aren't the same, but from our experience if you're just looking for a better drive and the ability to make the same or more power I think the divided G30 770 would probably be the smallest I'd go to.
    • Great work Duncan, any events local you will give it a test once all done? 
    • Sweet, yeah hoping stock gears will hold up. May use the transbrake feature on hill climb starts so that will test it.
    • Yeah, the thread is only nearly 20 years old.
    • Been down in Tassie for 2 weeks (a cruise, not a race for once) but spent a little time on her when I got back. I worked out the injector settings in the PowerFC were not correct for nismo 555s, set those to 66% +10ms and added a little air at closed throttle, set the timing (approximately, because it has some weird non 15o cells around idle) and now she starts and idles properly. She purrs like a kitten (ignore the co2 alarm in the background, I did  ) 20250518_171052.mp4 Next step, off for run-in, tuning and alignment!
×
×
  • Create New...