Jump to content
SAU Community

Recommended Posts

thinking about selling one of my toys.

1992 R32 GTS-t,

Engine;

RB30 block

RB25de head with n/a cams

GT30/76r turbo with anti serge front cover and 1bar Garrett actuator running 20psi

Am performance dump/screamer pipe

GTR injectors

Malpassi dual diaphram rising rate fuel regulator

Bosch motorsport 044 fuel pump

Microtech lt 12

300x600x75 FMIC

3.5" exhaust with decat pipe

Interior;

very tidy with no rip in seats or bubbles in dash

stock with boost guage and pioneer cd/mp3 player with 12" sub

Wheels;

Front: 19x8 Koya with nankang 245/35 R19 Tyres

Rear: 19x10 Koya with new Fedral 265/70 R19 Tyres

Suspension;

Lowered springs with KYB shocks

Adjustable castor/camber bushes

"SKYLINE" custom plates

post-44680-0-92266100-1297927350_thumb.jpg

$17000ono

ph. 0458977006

Link to comment
https://www.sau.com.au/forums/topic/354290-rb2530-r32-gts-t/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...