Jump to content
SAU Community

Recommended Posts

  • Replies 111
  • Created
  • Last Reply

Top Posters In This Topic

lol...bloddy nissan in mid 90s....make a nice car look like a land cruiser...lol...Clarence NOT MY FAULT :(

HAHAHAH!!! @ cass....ill wait for you to rock up and vll see whos is higher.. :D

PS - All good now with your car?

Sent out PMs to all participating - please let me know if you haven't got it.

I have not been able to send to GTTR34, as it says user is not accepting any new messages - does anyone have any alternate contact details so I can contact him?

Ya Brian? out again? :P coz this time i am sure ill be out...cant wait to cruise around with the 2 sexy GTRs (Brian's + Cass's)

Ill be in my RED BEAST!!!..lol...jks..maybe the slow silver baby this time :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...