Jump to content
SAU Community

Recommended Posts

Ok I have just been offered a drillers offsider position and I can choice either surface or underground.

Just wondering if anyone here has any experience in the drilling industry.

Both positions are fifo, 2 and 1 roster and pretty similar pay. (underground slightly more)

Link to comment
https://www.sau.com.au/forums/topic/357567-drillers-offsider/
Share on other sites

i had this a few years ago(not with drilling). experienced in open cut and thought about u/g but thought for only $2 difference why go down.they preferred i stuck with open cut anyway. from what ive seen it looks like a very phsyical job and you would sleep well at night. what sites are available?

Yeah dont worry I don't make big decisions from info on the net lol, after speaking to people that work underground seems if your with the right company at the right site its well worth it but as I am unsure where I would be located id prefer to stay on the surface.

  • 4 months later...
  • 2 weeks later...

i work underground, what sort of offsider? we talking nipper or diamond drill offsider?

Diamond drilling mate. Eventually went underground and loved it but had a run in with supervisor lol.... now Im on the surface with another company. Would like to go back underground but as a nipper/truckie, as diamond drilling is crap haha

What site you at?

  • 1 month later...

Aren't we all.

I missus' dad and mum both work in the resource industry

Mum is at perth mint gold refinery

And the dad is up on some three rivers site.

Only reason I haven't been able to work up there is due to not having any of the needed qualifications.

is it possible to get a job on the mines without HR licence?? really keen to earn some decent coin

depends what you wanna do. if you want to drive trucks then prob not. but if your on the tools/driller etc then you should be ok. some places will organise cops to come to site when they have a group of people who need HR. maybe get HR learners permit to show your interested?



  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...