Jump to content
SAU Community

Recommended Posts

Hey everyone, just kinda curious about something. For a long time now when im cruising at about 50 my stag kind of lumps along like the wheels are square or it's got a big cam or something, I've also got a massive constant shudder through the steering wheel that throws your hands off the steering wheel under braking but I think that's just warped discs. Could the lumping along be the brake discs too? Also anyone know the part number for hand brake shoes?

i'd start with the simple stuff like a wheel alignment and balance.

if that doesnt fix it, it sounds like a symptom of attessa issues - different diameter tyres front and rear? even worn tyres on the front or rear can throw it out and cause that constant driveline shudder as it swaps torque back and forth rapidly.

i have that same problem, i have diff size wheels, im running 225 45 17 on front and 235 45 17 rear, so my atessa keeps bumping up and down, so i just put it in RWD mode till i can be bothered fixing it, usually happens when im cruising at higher speeds where its more noticable around 140ish you feel it alot

Had a full front end rebuild, including wheel bearings, alignment and even a new hub and hub mount plate, new tyres all the same size(225/45r18, too small for speedo), they are balanced( Mayb not round), does it in rwd mode also.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...