Jump to content
SAU Community

Recommended Posts

Just for you Tony haha

Sorry I just had it with people trying to get money out of people lately...was had by Avis big time last week :( Twice the charge on my card that they quoted me.

Avis Toowoomba?

Going down the pipe was better than getting sucked back into the cylinders and chewing my pistons apart. Suprised they lasted the 7 years I've had it and god knows how long previously at 14psi.

I know a certain person in this thread that has a few choices of turbos lying around ;)

He's a turbo whore and chops and changes whenever he sees fit.

Said person might even still have his ceramics if you just wanna do a swap.

Btw, inconel compressor + exhaust wheel FTW :P

I'm a firm believer in if it breaks, fix it so it won't break the same way again. Ceramic turbos are on my shit list forever now. It's either a set of high flows or low mount garrets. Won't be for a little while, gotta recover from moving interstate and christmas and get the house all sorted first. Girlfriend has a list.

I'm a firm believer in if it breaks, fix it so it won't break the same way again. Ceramic turbos are on my shit list forever now. It's either a set of high flows or low mount garrets. Won't be for a little while, gotta recover from moving interstate and christmas and get the house all sorted first. Girlfriend has a list.

Ooooooor a big ass high mount precision cause you're not economic girl man ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...