Jump to content
SAU Community

Recommended Posts

found these parts again.

advertising for $500 each.....

feel free to make an offer, just using links to the site i got them on, hopes thats ok with the mods, took me ages to upload pics there.

not really interesting in posting outside vic much rather pick up

damaged repaired,

more pics available, pm or email me for request [email protected] subject dolphin items.

http://www.carparts.net.au/ads/dolphin-rear-bar-nissan-stagea/

http://www.carparts.net.au/ads/stagea-dolphin-side-skirts/

Link to comment
https://www.sau.com.au/forums/topic/364210-dolphin-side-skirts-rear-bar/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...
  • 3 weeks later...
  • 4 weeks later...
  • 3 months later...
  • 5 weeks later...
  • 4 weeks later...
  • 4 weeks later...

pretty sure they are for a c34 stagea not a m35 axis bud. Importmonster is prob your only bet with parts for your car. You could try and hunt at wrecking yards but it will be a needle in a haystack. Listen to the guys on your thread they know plenty off knowledge on these cars and like you have tryed to find parts with little to no luck and found importmonster the sure thing for these cars.

pretty sure they are for a c34 stagea not a m35 axis bud. Importmonster is prob your only bet with parts for your car. You could try and hunt at wrecking yards but it will be a needle in a haystack. Listen to the guys on your thread they know plenty off knowledge on these cars and like you have tryed to find parts with little to no luck and found importmonster the sure thing for these cars.

Either this, or Iain's shed! :nyaanyaa:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...