Jump to content
SAU Community

Recommended Posts

Les Lothringer's Approach to Remove / Reinstall Rear Bar on a Nissan R34 Skyline. May be applicable to similar Skyline models.

- Duration: Several minutes one person to remove / reinstall.

- Difficulty Level: Easy - once you know where the hidden attachments are. Refer photos for sequence.

- Special Tools: Plastic Plug Remover - see pix #6.

- Other Tools: Large Phillips Head Screwdriver, 1/4" 10 mm socket, 1/4" Extension Drives, background music of your choice.

- Parts: None, although plastic clips eventually break after a few installations.

- What Can Go Wrong: Hard to go wrong.

- Reference: None used.

Approach:

_____________________

Refer the sequence of photos for location of bolts, screws and plastic plugs, to first remove.

My link

Fitment is the reverse procedure.

_________________________________

- Les Lothringer's Disclaimer [short Form]: This describes my approach. If you choose to follow it and make a mistake, remember - at all times, it really is your fault, your risk and your cost. If you choose to follow it and get a different outcome, that's because you need to know more than what is described here. If you choose to follow it and something subsequently and in the rich fullness of time goes awry, you bear the consequences, deservedly or otherwise but probably deservedly. Recognize that your car may have been worked on by a previous owner who knew less than you do [scarey!!], who may not have applied good workshop practice or whom may have been a qualified workshop technician operating to unrealistic "industry standard job time" pressures and so took yet to be revealed shortcuts with unfortunate or even dire consequences or perhaps prepared the car for sale under instructions from a previous owner to "keep it cheap mate". If you lack the confidence, ability, manual dexterity, clear eyesight, intelligence, mental clarity, patience, emotional stability, knowledge, focus, correct tools, time and a firm, level under-cover location free of rain, flood, high winds, blizzards, sand storms, ground instabilities, ionizing radiation, blood sucking insects, inadequate lighting, excessive noise, distractions, subterranean volcanic activity, very low flying aircraft, terrorist actions, foreign invasion, etc etc etc, or otherwise believe in the power of prayer to keep you from screwing up in the performance of these tasks or even worse, possess a wife [or wives] or partner [or partners] pestering you to complete the work in what seems to her [them] to be more than a very reasonable affluxion of time, engage someone who does not. No responsibility accepted for srorre, omissions, misguided and unjustified assertions. Every car can be different. Your car may have design defects courtesy of the manufacturer [probably does] or aftermarket manufactured parts applied [quite possibly and made to another engineer's standards or maybe a committee of engineers with the usual interference from cost accountants (I did cost accounting)] or outstanding campaigns issued against it, as yet unapplied or applied incorrectly or components designed / manufactured under no intention of being serviceable [built-in obsolescence]. Torque settings as per Nissan WSM's.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...