Jump to content
SAU Community

Recommended Posts

Have a bit of issue with my cold start.

It starts low revs turns off , next start fires up fine.

This only happen when its cold, i cleaned aac valve and check for air leaks.

If i disconnect aac all together , brown and purple plug makes no diff to start.

Any ideas , could aac valve be gone?

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/
Share on other sites

You'll see it ontop of in the intake side of the plenum towards the front. It has a yellow warning stick saying NEVER OPEN WHEN HOT. I don't think that will have any effect. My old car done EXACTLY the same thing, cold morning starts it would crank start then die after a couple of seconds unless I blip the throttle. The problem went away as soon as I fitted my power fc. I never found out what the problem was though.

Its not likely to be the AAC valve faulty as with a Power FC this issue is non existant.

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5928965
Share on other sites

mate, just check your fuel pressure regulator. disconnect tiny vac hose connect to the plenum and start the car. see any change. if it starts fine it's your fuel pressure regulator. what happen was your cold morning enrichment was very lean. then change your pressure regulator.

make sure to put it back tiny vac hose b4 you driving. let me know how u go.

Thanx , it is weird car warm and starts fine idle fine. I changed spark olugs, coils are new, fuel filter,checked afm,new collant sensor but i did not try bleeding coolant , will see how i go . I hope it fixes it

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5929114
Share on other sites

i'm having this problem nearly 1 year[r33 s2]. not solve yet. what i found was i'm loosing fuel pressure when car stops for a wile. after 10-15 hrs car stops pressure completely loose in injector rail. i checked with pressure gauge. i'm waiting for my new fpr.

if u can try to clean your injectors.[remove and take it to inj cleaning place.] if u are in sydney let me know i will do it 4 u free.

Tried fpr and same thing, also bleed coolant and also no help. Im stumped to what it is.

Anymore suggestions?

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5929254
Share on other sites

yes i am a mechanic. it cant be fuel pump. i already change the pump. but no luck.

this cold start issued caused lot of things.

chk ur earth points,batt voltage, spark plug heat range+gap , vac leaks etc.

if above all ok chk ur fuel pressure with pressure gauge. see what happen to ur pressure in cold mornings or after long stay start.

pm ur no will call u.

Could it be fuel pump? Are you mech or just know someone that does fuel injector cleaning. Yes im in sydney

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5929279
Share on other sites

Its your injectors, they are leaking when it gets cold. If you want to check this, prime the fuel pump 5 times before you crank the car (when its a cold start, if its warm the fuel will just vaporize). Your car will start up and run rougher than usual and stall faster.

You can also check this by pulling your injector rail out and pull the electrical plugs on them and prime the pump and you will see them drip fuel.

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5929519
Share on other sites

The fuel we have in australia has probably wrecked the injectors. You can get them cleaned but its about $200 and you run the risk of it doing nothing as they could be damaged. A set from JECS which are the genuine nissan ones cost less when you buy them from USA online than Nissan selling them to you. Its less then $600 too your door for the 'Genuine ones', or maybe its time to upgrade them.

Yes this has happened to my car, i just know that its injectors because if it were a sensor the problem would be intermitant where as our was just on start up and the fuel was vapourised on the first few cranks leaving the 2nd start up to not run a lumpy rich start.

*NOTE if you have seen car run a RICH map they run the same but constantly so that how i knew it was fuel related

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5930408
Share on other sites

The fuel we have in australia has probably wrecked the injectors. You can get them cleaned but its about $200 and you run the risk of it doing nothing as they could be damaged. A set from JECS which are the genuine nissan ones cost less when you buy them from USA online than Nissan selling them to you. Its less then $600 too your door for the 'Genuine ones', or maybe its time to upgrade them.

Yes this has happened to my car, i just know that its injectors because if it were a sensor the problem would be intermitant where as our was just on start up and the fuel was vapourised on the first few cranks leaving the 2nd start up to not run a lumpy rich start.

*NOTE if you have seen car run a RICH map they run the same but constantly so that how i knew it was fuel related

My car had the same issue as him, why did the problem completely go away when I fitted a power FC?

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5930597
Share on other sites

Hmm not sure . Is aac valve allways adjusting idle? If i unplug it while car runs nothing changes

Turn your air conditioner on, that tells the AAC to let more air in to raise the idle and keep the car on. If nothing happens then, could be your AAC. But mind you, my car did do EXACTLY what you are saying here, it starts cold first time spluters and revs just die out. As soon as we fitted a power FC the problem is gone.

Link to comment
https://www.sau.com.au/forums/topic/371837-cold-start/#findComment-5935151
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...