Jump to content
SAU Community

Recommended Posts

Going from a dbl garage to a carport so it MUST go (unless some has some space)

32 Gtr custom intercooler 600x310x100 cast in/out and mounts

2 x R33 sideskirts

2 x R33 front guards L&R colour Black

R33s2 Carbon fibre over fibreglass bonnet

R33s2 boot lid and wing

R33s2 front bar

r33s2 headlights x 2 L&R

R33s2 foglights blinkers x 2 L&R

Enkei racing rims18x8 & 18x9 2 each with new Federal RSR rubber 34&38 offset

R33 3inch stainless catback exhaust

Rb25 head with manifolds

Rb25 fuelrail and injectors

Rb25 S2 coil packs x 10

R33 side blinkers X 2 (orange) L&R

R33s2 front seats x 2 L&R

R33s1 passenger seat

R33 radiator

R33 GTR Brembo front brakes with braided lines

Sard FPR

RB26 standard rods

small air compressor

small drill press

wooden work bench with roller draws

200 amp Tig welder

there is more and will add them as I find them

I know what each item is worth BUT I will take any reasonable offer BECAUSE I cant hold onto them any longer than a few weeks (excepting the Brembos)

So make an offer NOW before someone else does

I will post pics on demand

PM for any Querys I will get them!

Link to comment
https://www.sau.com.au/forums/topic/373468-moving-house-clearout/
Share on other sites



  • Similar Content

  • Latest Posts

    • Well, yes, every CU on the bus is available via the Consult port, but whether the scanner you are using is capable of talking to the TCU, the ABS/TCS modules, etc etc, is what is at question here. Many of them are only for engine codes. So, if you have one of those, you won't know if the ABS is having a bitch.
    • That's now. R chassis Skylines come from a time when the tolerance in the ADRs was a bit more....slack. My car, on 235/35-17, which is damn near the exact same size as the original 205/55-16, is pretty much bang on correct indicated speed across the whole legal range. That's demonstrated with constant speed run over 5km, and GPS speed. It's just the luck of the draw. My particular speedo head has to be the thing that is "calibrated" that way, because everything else (the diff ratio, the gearbox and the speedo drive**) are all same same as most other Skylines. **OK, so the speedo drive is a Navara unit to drive the R32's cable, not the electronic unit than an R33/4 would normally have with teh same gear on it. Otherwise, I applaud your OCD tendencies, and I would do the same if I needed to.
    • Not too sure, I believe the Nissan consult port does everything? Also just filled up the reservoir to full and the light is still on. The float seems to move up and down fine.
    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph on 255/40 17, so again conservative Google says manufacturers need to set the speedo from 4 to 10% slower than actual road speed.....for safety.....and compliance  After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
×
×
  • Create New...