Jump to content
SAU Community

Recommended Posts

For sale is my new unused rb26/30 built this for my daily but lost my licence so no longer need it located in Hobart Tasmania but can send anywhere in Australia cheaply

Rb30 vl block

Chemically cleaned

Resprayed black

Tapped for gtr head studs

Decked

Bored 40 thou

Torque plate honed

Rb26 head reconditioned completely by Lewis race engines sydney

Acl steel head gasket

Tomei metal intake gaskets

Complete rb26 plenum and throttles

Arp head bolts

Hastings chromolly piston rings

New oversized pistons

H beam conrods

Arp conrod bolts

Acl bearings

Balanced crank

Jun crank cooler

Crank grub screwed

Rb25 oil pump

New front and rear main seals

Gates timing belt

Chemically cleaned rb26 cam cover set with speedflow fittings fitted to the creatures

Cost over $6000 to build after $4000 Ono need a fast sale to fund my main project please email [email protected]

Link to comment
https://www.sau.com.au/forums/topic/376137-fs-rb-2630/
Share on other sites

It was for a vl commodore to replace the rb30et and if I separate the head $1500 it cost $1800 - $2000 plus postage from Lewis engines from memory pm me numbers and i ring people that are interested must be sold in the next couple of days

Link to comment
https://www.sau.com.au/forums/topic/376137-fs-rb-2630/#findComment-5999815
Share on other sites

  • 4 weeks later...
  • 2 weeks later...
  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...