Jump to content
SAU Community

Recommended Posts

Wanting to trade my 18" Volk f-zero challenge wheels for other wheels that will fit onto my r33 gtst.

Volks wheels are 18" x 9" + 45 and 18" x 10" + 48. They are white with a chrome edge. There is a few gutter rashes on all of the wheels unfortunately.. As far as buckles go they are fine as per what OTR in Clayton said.

They come wrapped with 235/45/r18 and 255/35/r18 federal 595 rs-r's. Ive only done about 2,500km on them and have been pretty covilized on them so they've got pretty much all tread left.

TO fit onto my r33 gtst all I needed was 20mm spacers for the front, the back sits on fine. My car has king springs with apexi tmax shocks so I'm not sure how much lower my car would sit than standard..

Basically just after something new to go on my car, plus driving around on semi slicks kinda makes me feel like I'm wasting them lol. So would like a trade for wheels to fit my skyline with no modding. The closer to filling the guards the better.. Also willing to sell them. As they are my only wheels though I will need passable wheels to swap with. Also willing to flog off the tyres themselves of you have crappy but roadworthy-able tyres I can swap with you. Pretty much tell me what you would like to sort out and I'll consider it.

Names Andy, I live in the eastern suburbs of Melbourne. Number is 0434145894. (SMS me for photos or I'll upload a couple pics later tonight)

Photos.. Sorry about picture quality I took them on my phone. they're also a little dirty, just wanted to see if somebody was interested

post-67844-0-23285400-1320915542_thumb.jpg

post-67844-0-96371100-1320915607_thumb.jpg

post-67844-0-19126400-1320915645_thumb.jpg

post-67844-0-99268800-1320915721_thumb.jpg

post-67844-0-57824400-1320915770_thumb.jpg

post-67844-0-71514000-1320915808_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Steam valve seals are usually responsible for cold start smoke, it goes away once engine warmed up. Disconnect it let engine breathers and let it breath freely, see if problem goes away after a short drive. Also check to make sure engine oil drain pipe is not blocked or kinked. 
    • Haha thanks! Yea I'm moving over from 2x 1000cc jets pre throttle over to 6x 190cc direct port jets and 1x 500cc pre throttle jet.  Direct port comes with all the advantages you would expect, except that pre throttle does cool down IAT'S more. That's why my direct port nozzle placement is closest to the plenum as possible in the runners to allow the air more time to cool before being sucked in. I'm also putting that one 500cc pre throttle jet to help with more cooling. It's a hybrid system. There's a lot more advantages to moving over to a PWM solenoid with a constant pressure system vs my old PWM pump setup, but I'll get more into that once I'm done converting everything over. The ricer in me is excited to see SS tubing all over my manifold though!
    • Very cool, see what I did there? 🥲 Wild WMI setup, first I've seen where it's on each cylinder runner, usually I see a single jet pre throttle.
    • Welcome mate. What type of work were you looking at getting done? Majorly of decent skyline workshops are in the SE.
    • Thanks mate, haha that's it ey, no more boosters and what not, should make for a good time
×
×
  • Create New...