Jump to content
SAU Community

Recommended Posts

  • Replies 76
  • Created
  • Last Reply

Top Posters In This Topic

I'm talking about the tray under the main floor, on top of the spare wheel well. I have heaps of crap on that. Have to compromise on something if I want a sub though :(

Pete hasn't done an M35 one yet so I'm sure he can make it however you need, most M35 owners will want something fairly practical I think?

Yup I need that tray above the spare wheel also

Keen as for this one .. Sooner the better! Was Spewin I missed Sundays Cruz !! Was ready to go right up2 few days b4! Could not even make 1st stop!

Twisties..pub lunch.. Chicken shop.. All sounds good!

Off topic ..

Put a custom twin 12inch in the back of my C34 so can still put leather boot cover to hide it And Amps n cap mounted behind rear seats so u can't c them.. All comp speakers behind stock grills n dyno matted doors! Sounds good an no one can c if they look in ! :thumbsup:

Looking through the list I believe the 10th would work best for everyone except Mat - is there no way that you could get the day off? SAU sucks, can't edit the first post and make a poll. :rolleyes:

Nah not really I do shift work so it's hard to get days off especially in December because everyone takes it off...ah well I'll hopefully be able to catch you guys on the next one or possibly maybe have a meet up get a feed talk a bit of bullshit?

  • 2 weeks later...

The last cruise had too much traffic. Start time was pushed back to avoid Christmas pagents, but we still had epic traffic to deal with.

I'd want to start at about 10, but I could do 11.30.

hmmm would help to have a set start time and a set meet point and a route worked out ????? just my 2c seems its thurs already , not sure if ill make this one got some work to do on the old girl first dont know if ill have time. Hey big kev why does sunday traffic bother you it is all going about same pace as you anyway :nyaanyaa: lol

hmmm would help to have a set start time and a set meet point and a route worked out ????? just my 2c seems its thurs already , not sure if ill make this one got some work to do on the old girl first dont know if ill have time. Hey big kev why does sunday traffic bother you it is all going about same pace as you anyway :nyaanyaa: lol

LOL last cruise details were sent out Friday morning.

Route and stuff isn't hard to sort out, it's just hard to find a time when everyone is keen. Sunday traffic is always rife, I figure any Sunday cruise is going to be a slow one. Can you even go for a punt in the hills nowadays? You'd be crazy to risk it at day time..

Depends on how stupid you want to be. You can't be too stupid on an open public road at any time.

If you're doing it this weekend pick a time and meet point and see how many can turn up. I should be right, I'll probably give it a go anyway. As long as we don't have more 40/80/40/80/40/80 baulking/accelerating sessions, I'm happy.

If Steven gets time to look at my car we'll be able to come, but at this stage i'm a maybe. Had to have my car towed today after everything stopped working mid-drive, suspected a dead fuel pump but it also has something to do with some other electrical issues :(

Depends on how stupid you want to be. You can't be too stupid on an open public road at any time.

By "go for a punt" I mean accidentally do a few km's over the speed limit and get booked a few hundred dollars for speeding and "street racing". :rolleyes:

Drive in the hills? Stare at your speedo, not where you're going.

Get a sense of humour chaps. next time we can all sit on 60 in an 80 zone and avoid accelerating and breaking altogether or even better could just sit in a car park and not drive at all waah waah waah lol. and start time and place and route where all organised well b4 Fri morning just not sent out till then for normal reasons ahhh got to love the internet .was not trying to have a bitch just saying its better to just organise a time and place coz your never going to pls everyone . flame suit on

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...