Jump to content
SAU Community

wheres all the nice cars ooo and where can i get 98 octane feul


Recommended Posts

  • Replies 70
  • Created
  • Last Reply

Top Posters In This Topic

bahh!!!!!!!!!! 350 at rears on 1.3 bar!!!!!!!!!!!

u would hate to get a bad batch of that 98 RON stuff.. goodbye engine!!!

anyone know where to get tolulene in decent quantity's and wether u need a licence to store it???

i know its not good to run in your car all the time, but good to have if u are going to the track or the strip.

Would you mind me asking what you do as a profession? cos for a young bloke, u seem to have had some pretty serious cars already.

Nar i live in sandy bay car is making 350kw at the wheels at 1.3 bar for the street but can wind it up to 1.7bar so it can make a bit more. yeah fuel does cost me quite a bit.
Nar i live in sandy bay car is making 350kw at the wheels at 1.3 bar for the street but can wind it up to 1.7bar so it can make a bit more. yeah fuel does cost me quite a bit.

As Tim the toolman would say; Oh! Oh! Oh! Oh! Oh!

Tim, Toluene is available at moto sport in newstead. They make it up to your specs and the price isnt too bad either. Love the stuff. 5 Litres every third or fourth tank does wonders

The gain in octane is up to you. If you tell them you want it to go from 95 to 98 then they'll make a suitable solution up for you. Just be careful with the stuff though, only use it in a well ventilated area as it causes cancer, it melts everything, so try not to spill any (I did once and half my shoe was left melted to the ground.) and never go over 1 litre per every 10 of fuel, put to much in and it will do more harm than good. But do it properly and you'll love it.

Whats Toluene do? I though it was just a crappy by-product of crude oil. Found this info below on toluene.

Too much toluene may breach Australian standards

(Archived)

HOME > NEWSROOM > NEWS RELEASE > 2000-03-01

Excessive amounts of toluene could mean that the octane performance of fuel used in cars may not comply with Australian standards in this area, according to Standards Australia.

Standards Australia was commenting on allegations regarding a “petrol substitution racket” in Sydney, in which petrol is allegedly being diluted with toluene to increase profit margins.

Octane performance is covered by an Australian standard, which requires that various grades of petrol meet specified octane ratings. The Australian Standard- AS 1876 of 1990 “ Petrol (Gasoline) for Motor Vehicles”- also sets out requirements relating to contaminants such as lead and sulphur content.

The octane rating controls the “anti-knock” performance of car engines. If the octane rating is too low, the engine will “knock” and this will affect both its performance and increase the prospect of engine damage.

The “knock” is the “pinging” sound which older cars would make when petrol with too low an octane rating was used.

The voluntary standard was developed by interested industry, consumer and government organisations such as the Australian Automobile Association, the Australian Institute of Petroleum, the Federal Department of Transport and the then State Pollution Control Commission.

Compliance with the standard would generally be the responsibility of the organisation who supplies the fuel to the service station. However, service station proprietors also have a prime role in ensuring proper storage and freedom from contamination.

This document last updated: 2000-03-01

The thing to remember with it is that you can mix up solutions of toluene to have your desired effect. It could be weak as heel or extremely potent. just depends how its mixed up for you in the first place.

Moto sport is on killa faddy (spelling?) road next to store it safe and that.

I use to run toulene in my gtir and it worked well. I use to get it from bp at selfs point in 20L drums

I use to get pure toulene so i use to run 4L of toulene to 20L of fuel. Never had a problem.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I can see between the water jacket and cyl 3 there wasn't a hard line of combustion gas. It certainly appears that the issue is coming from there. Yes, checked the tension. All at 100ft lbs where I set them 5 years ago. These blocks can crack but generally when they have been over bored. Mine is only 0.5mm oversize at 89.5mm. They break between cylinders around the 91mm mark. No sign of that with mine. My gut feeling is the head gasket lifted a while back when the studs stretched and i bandaided it by retorquing the studs. It's finally let go.
    • My Nismo 1.5 churps a bit on reverse turns when cold, but besides that feels like a stock diff.
    • Yes, but, I paid cash and I'm pretty sure the receipt was in the bin 10 minutes after I got home Note to self, keep all receipts
    • Bunnings would have just handed you your money back on that one!
    • So, version 4 intake is on its way I was looking at these a while ago but at around $200 or more it was a little pricey for something that might not work, but, I had it in my watch list, but, I got a message saying it was on special, and I had a code thingie to use, it eventually came in at $120 delivered, so BAM, BUY NOW.....LOL I'll need to have a look when it arrives but I feel it will "look" better than what I currently have, as it comes with a PCV fitting, so I will be able to get rid of the alloy pipe that goes to the throttle body with the PCV fitting  Well, that's what the voices in my head are telling me  Oh, and this happened today Yeap, it was a Trojan, and it was cheap, so I headed back to the hardware store and actually spent a little bit more on a heavy duty,  one that was actually recommended by a plumber mate, a Cyclone one with a fibreglass handle that is actually rated for clay The broken shovel will eventually be "modified" into a short handle shovel
×
×
  • Create New...