Jump to content
SAU Community

Recommended Posts

Hello!

I am stripping my beloved r34 GT-T and returning it back to stock.

So here are all the parts for sale, still currently on car (located in Melbourne) will remove upon purchase.

Prices can be negotiable!

img0837wd.jpg

Engine.

JJR Generic Front Mount Inter-cooler w/ return piping. to suit rb25 - $350 (good condition)

Splitfire Coilpacks to suit RB25det Neo - $370 (r34 GT-T)

HKS HI-power Silent 3 inch catback exhaust - $500 (Very Good condition)

3 inch High Flow cat -$150 (honeycomb has hairline fracture)

3 inch JJR Dump pipe - $150 (rb25det)

Generic Manual Boost controller - $25 (held boost fine)

Apexi SAFC Neo - $300

Handling.

Near new BC BR Coilovers to suit r34 GT-T. Spring rates F6 R8. Fully height + damper adjustable - $1000. (Excellent condition ~ less than 1,000 kms)

Genuine SSR Professor SP1 3pc wheels. 18 x 8.5 +30 // 18 x 9.5 +18 - $2,000 (gutter rash=cheap price)

25mm bolt on spacer - $100 (5x114.3)

15mm bolt on spacer - $100 (5x114.3)

Interior.

Recaro sr3 bucket seat (from DC2R) - $450 (average condition)

Recaro sr3 bucket seat (from unknown) - $550 (excellent condition)

R34 recaro seat rails. driver side rail - $220

R34 recaro seat rails. passenger side rail - $250

You can reach me on 0427 735 534

THANKYOU COME AGAIN

Edited by kenjz

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
×
×
  • Create New...