Jump to content
SAU Community

Recommended Posts

Hi Guys,

I am looking to sell my Skyline, to change to a GTR.

It is a 1995 Series 1.5 Silver R33 GTS-t (manual), bought as first owner in Australia in December 2002. When purchased, the car had 49,000 on the clock. The timing belt was done then, as was a complete service. The car was purchased completely stock (inclusive of M-spec kit and series 2 wing) and modifications have since included:

*K&N Pod filter with Cold Air Box and feed from front bar;

*ARE bar and plate FMIC, custom stainless steel piping;

*HKS SSQV BOV hidden behind front bar;

*Infinity Q45 throttle body

*Greddy front facing intake plenum

*Trust Adjustable Exhaust Cam Wheel

*Trust Profec B spec II electronic Boost Controller

*Full exhaust – Stainless split dump, Trust 3” front pipe and Catco high flow cat, Trust V-banded 4” cat back Power Extreme;

*Exedy high capacity Organic Clutch;

*Trust oil pressure gauge and boost gauge on A-pillar;

*R33 GTR dash cluster (purchased showing 50,000 kays, now done 70,000);

*Pivot Turbo Timer;

*DBA Slotted rotors, Endless pads (set of RB74s included)

*Stealth wing (original included);

*18 x 8 with 235/45 front, 18 x 9 with 265/40 rear Buddy Club P1 Racing II’s and Michelin Pilot Sports (5 months old);

*JVC Chameleon deck;

*Trust shifter.

The car has always run Motul 3000V oil or Mobil 1, and has run Redline diff and gearbox oil. The engine oil has always been changed at 4000 – 5000 kays, and the car is meticulously maintained.

This is one of the neatest R33 GTSt you will see.

Asking $24,500

Link to comment
https://www.sau.com.au/forums/topic/39444-for-sale-r33-gtst-melbourne/
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Resizing injectors in Nistune can be done a couple of ways, and there are a couple of ways that you can make a mess of it. The tuner needs to be really aware of the effects of whichever approach he uses (either K, or TIM). They are both easy enough to "get the injector size right" to run the engine. But little details like old start enrichment and hot start are affected differently, depending on which boxes you check.
    • Pretty safe to say almost everyone that has tuned their own car has experienced this issue. The difference being that we have our laptop in the car and when it happens, it's literally 10 seconds of tuning to sort it.  Would you be happy to plug in your laptop and sort this yourself? It is a very simple process and there is no risk of harming your engine (if you are worried about that). 
    • Yeah thats the next step now, either they wil or i will take out for a drive to work and go straight their after work and see is we get the same issues 🤞  thought i try my luck here too, never know someone else might have had the same issue but thanks for the reply 
    • Basically your tuner needs to drive it for the 30 min (or whatever) to create the same conditions then check the ECU settings and sensors at that time. They may not be excited to because that takes them 30 min rather than just opening the bonnet and seeing the problem straight away.... Hot start is generally not as tricky as cold start, but there would be a table for fuel enrichment vs coolant temp as a starting point
    • Yeah, they all cant say anything for sure as everything is working fine . Said unable to find an issue untill it stops again. Could mist likely be CAS wiring or IAS valve issue but again not 100%
×
×
  • Create New...