Jump to content
SAU Community

Koya Driftechs 17X9.5 17X10


Recommended Posts

Hey guys I am selling the old rims and tyres off my gtr. The two fronts are 17x9.5 and the rears are 17x10, I'm pretty sure they are Koya's they were on the car when i bought it. All four rims have 255 ku36 rubber which are all pretty close to the indicators.

One of the fronts has got a crack in it i will attatch a photo of it but the other three are in pretty good condition.

I am after $400 but will take any offers

Any questions you can contact me on 0412473767

If you want to come have a look i like in Cloverdale WA (I wont be here for three weeks but house mates will be.)

Ben

post-92570-0-25266700-1334745586_thumb.jpg

post-92570-0-57712400-1334745623_thumb.png

post-92570-0-51130200-1334745650_thumb.jpg

post-92570-0-41410400-1334745676_thumb.jpg

Link to comment
Share on other sites

hey guys so a couple people have asked me to measure the offset which is 140mm and i noticed they all have 9 1/2 stamped on the back but they measure up 255mm so im sorry but cant gaurantee the size now. fail. But anyone interested is more than welcome to come have a look and measure them for themselves.

cheers

ben

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Latest Posts

    • So today I went well outside my comfort zone (again) to replace my valve cover gasket.  I have had a big leak over the exhaust leading to a lot of smoke and smell every time I drove it. The leak was in the rear driver's corner.  The job wasn't hard as such, just a bit finicky and time consuming.  The old gasket was rock hard and broken right where the leak was.  The leaky corner had so much sitting oil in it.  The good news to my amateur eyes was no buildup or sludge under the cover. It all looked fairly nice in there.   I haven't started it yet. I ran out of light and body when putting the coils and injector loom back in. Probs only 30min left for the morning.  I was so nervous putting the cover back on, I must have lifted it 5 times to make sure the gasket was still seated properly. God it's going to be nice to be leak free and not make other traffic light queuers think my car is about to explode.
    • Gave the Mazda it's first wash, it will need some clay, a light compound, and polish polish to remove a few swirl marks, but that will be a job for when I have a full day to get my DA polisher action on
    • Just did this job on my 32 with the boost doc kit. was quite simple to fit, hardest part was getting the rubber bungs back on the firewall. does anyone know how the heater will work now without the flap in the bend? Will I just have a heater on 24/7 now?
×
×
  • Create New...