Jump to content
SAU Community

Recommended Posts

Will be ordering from the USA again very soon. Sewell Infiniti has won me over.

Anyone wanna get in on it to save on postage. Usually through FedeX so it arrives pretty fast.

NO big huge major parts just small odd'n ends.

If you have the part number that would be even better, if not describe it to the best detail you can.

If your keen reply to this with what it is/part number etc and I'll give them a call and get quotes and what not!!

Link to comment
https://www.sau.com.au/forums/topic/399900-ordering-from-the-usa-again-soon/
Share on other sites

Wonder how much window motors and door actuators cost from them?

same bro my driver side window sounds like its starting to die and the Auto function on my driver side doesn't work. If you find out on prices please post here

Edited by Seano350GT

I can ask when I ring tonight because I have to ask about a piece of plastic that sits infront of the radiator.

Would make it easier when seeking cost to quote the part name - if your haven't already run across this, check here. It's a link to Infinity LHD models, but most parts in common:

http://psedog.com/cars/fsm/g35/coupe/

Start with either the fwd.pdf (contents) or idx.pdf (index).

I have the part I broke with the part number on it. Just need a new one, might get a heap of those little circle black clip things too, anyone need any of them critters? I know I need atleast 10 or so

Would make it easier when seeking cost to quote the part name - if your haven't already run across this, check here. It's a link to Infinity LHD models, but most parts in common:

http://psedog.com/cars/fsm/g35/coupe/ thanks I found what I was after. Air intake duct passenger side.

Start with either the fwd.pdf (contents) or idx.pdf (index).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...