Jump to content
SAU Community

Recommended Posts

YES! havnt seen it in ages, could do a bbq/movie under the stars night :P

ok that sounded sooo gay lol

we should start organising a bbq asap, after we finish with F&F quotes :D

Yep full homo romantic spec!!

I have all 5 on blue ray just because they make me LOL

This thread was for Chit Chat, so derail away but on the odd occasion look like we are planning this meet so we dont get sent to the Wasteland :O

1 had the best one liners for sure..... 5 had good special effects......

I like 5 for the cool cars and the old school skyline at the start of the movie when Paul is driving through the slums

Then I think it was 4 for with the petrol tankers for the massive LOL's. Who knew cars could pull 10+ tonnes and go 50mph in reverse

And finally 1 for the sheer stupidity and one liners. Plus the longest 10 sec quarter ever complete with laptop on passenger seat.

"Danger to manifold"

I forgot about 3 mainly cause of the big turd that it is

EDIT. Bout the only good bit of that movie was the stuck up blonde getting injured at the start

Oh and trying to drift a FWD Lancer on the docks with expert commentary from the old fisherman

Edited by m.j.h

I forgot about 3 mainly cause of the big turd that it is

EDIT. Bout the only good bit of that movie was the stuck up blonde getting injured at the start

Oh and trying to drift a FWD Lancer on the docks with expert commentary from the old fisherman

You don't know who the old fisherman is do you? :/

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...