Jump to content
SAU Community

Recommended Posts

upgrading i have the followong parts FS

std turbo t28 off r33gts-ts2 97,this turbo have alway run stock boost,i dont have a boost control until now,run 168kw atw at stock boost can show dyno sheet. from inspection;the turbo rotor shaft turn smoothly when pushed with finger,not loose when moved right/left. NO carbon slubge acccumulation,NO change in colour with rotor shaft. turbin wheel/compresser wheel no greese no carbon,turbine wheel blade in top condition with actuator

i Want $500...

std alloy wheel..stock rim 17" still very good condition.70-80% meat...$400

std cat back...... $offer

std r33 gtst s2 97 ECU.....$offer

std intercooler........$70

std BOV ...............$50

std 6xinjector.........offer

std fuel pump..........offer

std fuel regulator.....offer

pm or email me [email protected]

fairfield..sydney

thanks!

Link to comment
https://www.sau.com.au/forums/topic/40270-fs-std-r33gtsts2/
Share on other sites

hey mate i consider it.........my dad is heading down there next week....i let u know by monday and u can pick it up of him.......but for now i need better offer as the turbo is in really good condition and i been looking after my car.. pm me ur mob number thank

Link to comment
https://www.sau.com.au/forums/topic/40270-fs-std-r33gtsts2/#findComment-826091
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes the gear for the R33/34 is different, it is red and has a different number of teeth. My part didn't come with that gear though, so I don't know how many teeth are on the red one. You'd have to reuse the 260RS/R33 gear, as long as it's not destroyed.   Haha, as unfortunate as that might be it was working fine for about the first 1500km I've had the car for now.
    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
×
×
  • Create New...