Jump to content
SAU Community

Rebuilt Rb25Det Oil Pressure Light Not Going Off

lara........
 Share

Recommended Posts

lara........ Newbie

lara........

Posted
Posted

My rb25det has been fully rebuilt and have just put it in it starts and seems all good no noises or knocks but the oil pressure light stays on and the gauge isnt working. Tested wires from sensors and they are working fine. Does anyone have any ideas tips or tricks ta help out

GTRsean Grand Master

GTRsean

Posted
Posted

Pull the CAS plug out and crank over for 15 seconds till oil light goes out. If it doesn't, wait for a minute, then crank for another 15 seconds.

If it's still no good by then, check oil levels, and contact engine builder...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • svenskalice
      Kaizo Industries

      By svenskalice · Posted

      Oh, also, forgot to add these photos I believe.
    • svenskalice
      Kaizo Industries

      By svenskalice · Posted

      Thought i'd update on this. I was able to get in contact with Craig Lieberman and later on Darryl Alison (owner of Kaizo Industries). Darryl was able to help me verify that my car was in fact one of theirs and is helping me find more info on mine !
    • GTSBoy
      RB26DETT Sketchy boost mod?

      By GTSBoy · Posted

      There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • GTSBoy
      Cas issue

      By GTSBoy · Posted

      The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
×
×
  • Create New...